Einrichtung zum Verteilen des Arbeitsmittels auf mehrere parallel
geschaltete beheizte Rohre Bei mehreren parallel geschalteten, an -einen Verteiler
angeschlossenen beheizten Rohren, die von Wasser oder Dampf oder einem Dampf-Wasser-Gemisch
durchströmt - sind, kann es besonders bei kleinen Lasten leicht vorkommen, daß sich
,das Arbeitsmittel verschieden auf die einzelnen parallel geschalteten Rohre verteilt.
Die Folge hiervon ist, daß einzelne Rohre von einer zu geringen Menge des Arbeitsmittels
durchströmt sind ,Lind infolge der Beheizung leicht zerstört werden können. Zur
Vermeidung dieser ungleichen Verteilung ist es bekannt, den einzelnen Rohren der
Rohrbündel. Strömungswiderstände, z. B. Düsen, vor- oder nachzuschalten. Die richtige
Bemessung dieser Widerstände ist jedoch schwierig, da diese Widerstände einerseits
bei kleiner Last so groß sein müssen, daß mit Sicherheit eine gleichmäßige Verteilung
und Strömung auftritt, andererseits muß aber bei Spitzenlast der durch diese Widerstände
hervorgerufene Druckverlust noch tragbar sein. .Device for distributing the work equipment to several in parallel
Switched heated pipes With several parallel switched on one distributor
connected heated pipes made of water or steam or a steam-water mixture
flow through - it can easily happen, especially with small loads, that
, the work equipment is distributed differently to the individual pipes connected in parallel.
The consequence of this is that individual pipes are affected by too little of the working medium
are flowed through, and can be easily destroyed as a result of the heating. To the
To avoid this uneven distribution, it is known to use the individual tubes of the
Tube bundle. Flow resistances, e.g. B. nozzles, upstream or downstream. The right
However, dimensioning these resistances is difficult because these resistances on the one hand
with a small load must be so large that a uniform distribution is guaranteed
and flow occurs, on the other hand, however, at peak load the must through these resistances
caused pressure loss can still be tolerated. .
Gemäß der Erfindung werden daher neben einem für eine Grundlast bestimmten
und über Drosselvorrichtungen mit den beheizten icohren des Dampferzeugers verbundenen
Verteiler weitere Verteiler vorgesehen, die entsprechend der Last über Zweigleitungen
mit Ventilen einzeln an die Zuführungsleitung des Arbeitsmittels zu= oder abgeschaltet
werden können und mit den Rohren ebenfalls über Drosselvorrichtungen und Zweigleitungen
dieser Rohre in Verbindung stehen. Die dampferzeugenden Rohre sind hierbei also
an mehrere Verteiler angeschlossen, und zwar wird bei bestimmten Belastungen der
Strom des Arbeitsmittels auf mehrere parallele Verteiler verzweigt, so daß an den
mit Drosselvorrichtungen versehenen Enden der Rohre bei bestimmten Belastungen kein
unerwünscht hoher Druckabfall auftreten kann. Werden
beispielsweise
zwei Verteiler vorgesehen, an die das Rohrbündel angeschlossen wird, Si# wird der
zweite Verteiler bei größeren lastungen als.Halblast eingeschaltet, so d--il:) die
Drosselvorrichtungen bei Vollast von annähernd der gleichen Menge des Arbeitsmittels
durchflossen sind wie hei Halblast und ein unzulässig hoher Druckabfall hierbei
nicht auftreten kann. Es kann infolgedessen bei allen Belastungen der Druck des
Arbeitsmittels annähernd gleich sein, so daß auch die das Arbeitsmittel fördernde
Pumpe mit dem gleichen Druck betrieben werden kann. Ist nitr einer der Verteiler
eingeschaltet, so kann die Strömung nicht durch Umleitungen durch den anderen Verteiler
gestört werden, da die Umleitung außer dur ch die U mlenkungen und Erweiterungen
durch zwei Drosselvorrichtungen gehindert wird und auch solche Drosselvorrichtungen
verwendet werden können, die in der einen Richtung einen gröl:)ereii Widerstand
haben als in der dem Betriebszustand entsprechenden Strömungsrichtung. Das zum Abschalten
der zusätzlichen Verteiler dienende Ventil kann auch selbsttätig in Abhängigkeit
vom Druckabfall in den Drosselvorrichtungen gesteuert werden, so daß die Aufrechterhaltung
des zulässigen Druck= verlostes ohne Schwierigkeiten selbsttätig erreicht werden
kann.According to the invention, therefore, in addition to one for a base load
and connected to the heated pipes of the steam generator via throttle devices
Distributor further distributors are provided, which according to the load via branch lines
with valves individually connected to the supply line of the working medium or switched off
can be and with the pipes also via throttling devices and branch lines
these pipes are in communication. So the steam generating pipes are here
connected to several distributors, and with certain loads the
Stream of the working medium branches out to several parallel distributors, so that to the
ends of the pipes provided with throttling devices under certain loads no
undesirably high pressure drop can occur. Will
for example
two distributors are provided to which the tube bundle is connected, Si # becomes the
second distributor switched on for loads greater than half load, so d - il :) die
Throttling devices at full load of approximately the same amount of working fluid
flowed through are like hot half load and an impermissibly high pressure drop here
cannot occur. As a result, the pressure of the
Working medium be approximately the same, so that the working medium also promotes
Pump can be operated with the same pressure. Is nitr one of the distributors
switched on, the flow cannot be diverted through the other manifold
be disturbed, as the diversion except through the diversions and extensions
is prevented by two throttling devices and also such throttling devices
can be used that have a gröl:) ereii resistance in one direction
than in the direction of flow corresponding to the operating state. To switch off
the additional distributor serving valve can also be automatically dependent
be controlled by the pressure drop in the throttle devices, so that the maintenance
of the permissible pressure = raffled can be reached automatically without difficulty
can.
Ein :kusführungsbeisliiel der Erfindung ist in der Zeichnung dargestellt.
Die Rohre .l des Rohrbündels sind an einen Verteiler i und mittels der Zweigleitungen
3 an einen Verteiler 2 angeschlossen. An den Mündungen der einzelnen Rohre und Zweigleitungen
sind Düsen ; vorgesehen. Der Verteiler 2 ist über ein Ventil s bzw. einen Schieber
mit der Zuleitung 6 für das Arbeitsmittel verbunden.An example of the invention is shown in the drawing.
The tubes .l of the tube bundle are connected to a distributor i and by means of the branch lines
3 connected to a distributor 2. At the mouths of the individual pipes and branches
are nozzles; intended. The distributor 2 is via a valve s or a slide
connected to the supply line 6 for the working medium.
Bei voller Last ist das Ventil s geöll'net, so daß (las Arbeitsmittel
in beide Verteiler fließt. Bei Halblast ist das Ventil 5 geschlossen, so daß dann
das gesamte Arbeitsmittel nur durch den Verteiler i strömt. Der Verteiler i wird
somit bei halber Last von der gleichen Menge des Arbeitsmittels durchflossen wie
bei Vollast, so dala an den Düsen in beiden Fällen der gleiche Di-ticl;vc-i-iust
auftritt.At full load the valve s is open, so that (read work equipment
flows into both distributors. At half load, the valve 5 is closed, so that then
the entire working fluid flows only through the distributor i. The distributor i becomes
thus, at half load, the same amount of working fluid flowed through as
at full load, so dala at the nozzles in both cases the same di-ticl; vc-i-iust
occurs.
Es können auch drei oder mehr « Verteilc@itorgesehen werden, in welchem
Falle die zusätzlichen Verteiler bei einer entsprechenden Belastung zu- oder abgeschaltet
«-erden.It is also possible to see three or more «distribution lists, in which
If the additional distributors are switched on or off with a corresponding load
"-earth.
Die Erfindung ist von besonderer Bedeutung für Dampferzeuger mit Zivangutnlauf
oder mit Zwangdurchlauf für Vorverdampfer oder Vorwärmen also in allen den Fällen.
bei denen das Arbeitsmittel durch aus mehreren parallelen beheizten Rohren hestelictid;@
1@@@lirbündel getrieben wird.The invention is of particular importance for steam generators with Zivangutnlauf
or with forced flow for pre-evaporator or preheating in all cases.
in which the work equipment is hestelictid; @
1 @@@ lirbündel is driven.