<Desc/Clms Page number 1>
Appareil de Chauffage " Maec " pour l'utilisation des combustibles à bon marché.(Brevet n 339137.)
Le but poursuivi par le titulaire du brevet n 339137 ci-dessus rappelé était de réaliser un appareil donnant de la chaleur d'une façon commode, économique et hygiénique en utilisant des combustibles à bon marché.
Ce but à été atteint : 1 / En adotant le principe de la combustion en feu continu vif et a température élevée d'une masse restreinte de combustible, et de l'alimentation automatique et ininter- rompue de cette masse.
2 En ayant recours à un dispositif d'évacuation continue ou intermittente des cendres, permettant principalement, l'emploi d'un combustible d'un prix peu élevé eu égard à sa teneur en matières incombustibles.
3 En réduisant la résistance du foyer au passage des gaz par l'emploi " grilles verticales à grande ouverture " et permettant ainsi principalement l'usage d'un combustible ±'un prix peu élevé eu égard à son etat de division.
La résistance du foyer peut, encore être diminuée et un pas de plus peut être fait vers la combustion vive des combustibles menus en adoptant pour le foyer un dispositif présentant les caractères distinctifs définis ci-dessous, ou, tout au moins, dans les cas où d'autres considérations ne permettent pas de les retenir tous, certains des caractères distinctifs définis ci-dessous.:
1 Les gaz de la combustion s'échappent de la masse en ignition par une surface fermée MNPQ dont la forme et la position ne sont modifiées ni par un apport de combustible frais dans le foyer ou dans le réservoir, ni, en régime normal,par la combustion elle-même.
2 / Il y a sur les parrois latérales du foyer,au moins deux grilles situées daxs des plans différents et autant
<Desc/Clms Page number 2>
que possible, toutes les parrois latérales du foyer sont tapossées de grilles
3/ Au moins une grille s'étend en hauteur, plus haut que la partie inférieure de la surface M N P Q et peut dé- passer la partie supérieure de cette surface.
4/ Au moins l'une des grilles s'approche de la surface MNPQ jusqu'à la toucher ou, toutau moins, jusqu'à n'en être éloignée que d'une distance inférieure à la plus petite dimension de la masse en ignition.
Il est supposé dans ce qui précèue qu'il s'agit de grilles verticales à grande ouverture et à barreaux hori- zontaux et rectilignes.
C'est avec ce type de grille que les avantages dûs aux caractères ci-dessus sont les plus marqués.
Ces avantages se retrouveraient, cependant à un degré appréciable si l'on organisait un foyer selon les principes ci-dessus avec des grilles quelconques.
Il est à remarquer, encore, que l'ensemble de deux ou plusieurs grilles voisines à barreaux rectilignes peut être remplacé par une seule grille à barreaux courbes dont le tracé épouse en projestion horizontale la forme de la ligne brisée correspondant à une suite de barreaux rectilignes.
Pour plus de clarté, citons comme applications des principes ci-dessus:
Un foyer Maec à feu continu pour le chauffage des appartements ( Planche I jointe. )
Un foyer Maec pour chaudières de chauffage central (Pl.Il)
Un foyer Maec pour cuisinières ( Pl. III )
La première de ces application procède des caractères 1,2, 3, et 4 ci-dessus.
La seconde tient des caractères 1,2 et 3. Il s'y trouve une grille intérieure circulaire ou polygonale à laquelle l'air accède, en tirage naturel, par les ouvertures A ou B.
L'appareil peut être soumis au tirage soufflé, l'air
<Desc/Clms Page number 3>
comprimé y étant amené,alors,en principe,par le conduit CD-Le conduit AB étant fermé en A et B sauf pour le nettoyage.
Cette application tient des caractères 1, 2 et 3.
Le troisième cas présente les caractères 1, 2 et 4.
L'application du foyer continu à une cuisinière y est rendue possible précisément à cause du principe adopté de la combustion vive et de la position constante de la surface d'évacuation des gaz qui permettent de donner - instantanément au foyer l'ardeur nécessaire tout près des aliments à cuire.
Certaines parois du foyer se sont pas garnies de grilles et chauffent les fours.
Toutes les armatures du foyer par lesquelles il pourrait se dégager de la poussièrre sont enclosea dans une enceinte fermée.
Seul y subsiste libre, l'orifice d'entrée d'air par lequel les poussières ne sauraient d'ailleurs s'échapper en raison du tirage qui s'y manifeste.
En résumé la demande d'un brevet de perfectionnement à laquelle la présente description est annexée se rapporte à une manière de réduire la résistance intérieure d'un foyer à feu continu et d'y rendre possible sans l'emploi de matières réfractaires la combustion vive et à haute température de combustibles plus menus que ce&x usités.
**ATTENTION** fin du champ DESC peut contenir debut de CLMS **.
<Desc / Clms Page number 1>
"Maec" heater for the use of cheap fuels. (Patent n 339137.)
The aim pursued by the holder of patent no. 339137 recalled above was to produce an appliance giving heat in a convenient, economical and hygienic manner using inexpensive fuels.
This goal was achieved: 1 / By adopting the principle of combustion under high continuous fire and at high temperature of a small mass of fuel, and of automatic and uninterrupted supply of this mass.
2 By using a continuous or intermittent ash evacuation device, mainly allowing the use of a low-cost fuel in view of its non-combustible content.
3 By reducing the resistance of the hearth to the passage of gases by using "large opening vertical grates" and thus mainly allowing the use of a fuel at a low price in view of its state of division.
The resistance of the hearth can be further reduced and a further step can be taken towards the lively combustion of small fuels by adopting for the hearth a device having the distinctive characteristics defined below, or, at least, in cases where other considerations do not allow us to retain all of them, some of the distinctive characters defined below:
1 The combustion gases escape from the ignition mass through a closed MNPQ surface, the shape and position of which are not modified either by adding fresh fuel to the firebox or to the tank, or, under normal operating conditions, by combustion itself.
2 / On the side walls of the fireplace, there are at least two grids located in different planes and as many
<Desc / Clms Page number 2>
as possible, all the side walls of the fireplace are lined with grilles
3 / At least one grid extends in height, higher than the lower part of the surface M N P Q and can exceed the upper part of this surface.
4 / At least one of the grids approaches the MNPQ surface until it touches it or, at least, until it is only moved away from it by a distance less than the smallest dimension of the ignition mass .
It is assumed in the foregoing that these are vertical grilles with large opening and horizontal and rectilinear bars.
It is with this type of grid that the advantages due to the above characters are most marked.
These advantages would be found, however to an appreciable degree, if a fireplace were organized according to the above principles with any grids.
It should be noted, again, that the set of two or more neighboring grids with rectilinear bars can be replaced by a single grid with curved bars, the outline of which follows in horizontal projection the shape of the broken line corresponding to a series of rectilinear bars .
For the sake of clarity, let us quote as applications of the above principles:
A Maec fireplace with continuous fire for heating the apartments (Plate I attached.)
A Maec fireplace for central heating boilers (Pl.Il)
A Maec fireplace for cookers (Pl. III)
The first of these applications proceeds from characters 1, 2, 3, and 4 above.
The second holds characters 1, 2 and 3. There is an internal circular or polygonal grid to which the air accesses, in natural draft, through the openings A or B.
The device can be subjected to the blown draft, the air
<Desc / Clms Page number 3>
tablet being brought there, then, in principle, by the conduit CD-The conduit AB being closed at A and B except for cleaning.
This app holds characters 1, 2 and 3.
The third case presents the characters 1, 2 and 4.
The application of the continuous fire to a stove is made possible there precisely because of the adopted principle of live combustion and the constant position of the gas evacuation surface which allows to give - instantly to the fire the necessary heat nearby. food to be cooked.
Some walls of the fireplace are not lined with grills and heat the ovens.
All the frames of the hearth by which it could be released from the dust are enclosed in a closed enclosure.
All that remains free is the air inlet orifice through which dust cannot escape due to the draft which occurs there.
In summary, the application for an improvement patent to which the present description is attached relates to a way of reducing the internal resistance of a continuous fire hearth and making it possible without the use of refractory materials for live combustion. and at high temperature fuels finer than usual.
** ATTENTION ** end of DESC field can contain start of CLMS **.