TS011-1.0.1 Relay

This revision fixes minor issues with MAC commands and brings more clarity to the specification, especially to the description of the back-off mechanism and the notification mechanism.

TS009-1.2.1 Certification Protocol

This protocol specification allows the LoRaWAN Certification Test Tool (LCTT) to fully validate compliance of an end-device to the LoRaWAN L2 Specification [TS001] and the LoRaWAN Regional Parameters.

TS001-1.0.4 LoRaWAN® L2 1.0.4 Specification

REQUIRED FOR CERTIFICATION: This document describes the LoRaWAN® 276 network protocol, which is optimized for battery277 powered end-devices that may be either mobile or mounted at a fixed location

TS002-1.1.0 LoRaWAN® Backend Interfaces

The primary focus of this document is to describe the message flow between the various entities of the network during the Over-the-Air Activation and Roaming Procedures of an End-Device.

TS011-1.0.0 Relay

This document describes the relaying mechanism used to transport LoRaWAN® frames bi-directionally between an end-device and Gateway/Network Server.

TS013-1.0.0 Payload Codec API

TS007-1.0.0 Multi Package Access

This document defines a standard application layer which provides information on the implemented package(s) and the FPort used on the end-device.

TS006-1.0.0 Firmware Management Protocol

This document proposes a standard application layer firmware management protocol.

TS005-2.0.0 Remote Multicast Setup

This document defines an application layer messaging package over LoRaWAN®.

TS004-2.0.0 Fragmented Data Block Transport

This document provides an application layer messaging package over LoRaWAN®.

TS003-2.0.0 Application Layer Clock Synchronization

This package is useful for end-devices who are unable to access an accurate time source.

RP002-1.0.5 LoRaWAN Regional Parameters

This document describes the LoRaWAN® Regional Parameters for different regulatory regions worldwide.

Errata CR - US915 and AU915 ChMaskCtrl Contradiction

RP002-1.0.4 introduced a contradiction in the use of ChMaskCtrl=5 for the US915 and AU915 regions whereby the use of bit 8 contradicted the definition of blocks of channels.

ERRATA_L2_1_1_D2D

This errata was created to remove the prohibition of end-devices from sending downlink frames for LoRaWAN Link Layer Specifiation 1.1.

ERRATA_L2_1_0_4_D2D

This errata was created to remove the prohibition of end-devices from sending downlink frames for LoRaWAN Link Layer Specifiation 1.0.4.

NwkId Length Fix for Type 3 and Type 4 NetIDs Errata on the LoRaWAN Backend 1.0 Specification

NetID is a 24bit network identifier assigned to LoRaWAN networks by the LoRa Alliance. Values 0x000000 and 0x000001 are reserved for experimental networks and networks that are not using roaming...

ADR – Harmonize State Transition Errata on the LoRaWAN L2 1.0.3 Specification

As LinkAdrReq commands also control the nbTrans (number of retransmissions) and this field is an integral component to how the network manages (in conjunction with data-rate and transmit-power) the...

FOpts Encryption, Usage of FCntDwn Errata on the LoRaWAN L2 1.1 Specification

The frame-options length field (FOptsLen) in FCtrl byte denotes the actual length of the frame options field (FOpts) included in the frame.