(54) ВОДОНАГРЕВАТЕЛЬ(54) WATER HEATER
ты 2. За счет разности нивелирных столбов в корпусе 1 образуютс холодный опускной и гор чий подъемный потоки воды. Благодар отбойному щитку 4 и патрубку 3, тангенциально установленному относительно боковой стенки корпуса 1, холодный поток воды приобретает винтовое движение вокруг пучка электронагревательных элементов 2. При этом гор чий поток воды поднимаетс вдоль электронагревательных элементов 2 и далее направл етс по кольцевому каналу 6 в сборник 7 кип тка. Кип ток отвод т по патрубку 8, а гор чую воду - по патрубку 5. Опуска сь, холодна вода перемешиваетс с гор чей водой, в результате чего образуетс шлам, который скапливаетс в нижней части корпуса 1. При очистке водонагревател стакан 9 вместе с электронагревательными элементами 2 вынимают из корпуса 1 и последний очишают от шлама. Элементы 2 и стакан 9 проход т профилактический осмотр, при необходимости очищаютс от отложений и затем легко вставл ютс в корпус 1 на свое место. Водонагреватель готов к эксплуатации .You 2. Due to the difference of the leveling pillars in the housing 1, cold descending and hot rising water flows are formed. Due to the baffle plate 4 and the nozzle 3, which is tangentially installed relative to the side wall of the housing 1, the cold water flow acquires a helical motion around the beam of electric heating elements 2. At the same time, the hot water flow rises along the electric heating elements 2 and then goes along the annular channel 6 to the collection 7 kpka. The boil is discharged through the pipe 8 and hot water through the pipe 5. Going down, the cold water is mixed with the hot water, resulting in sludge that accumulates in the lower part of the casing 1. When cleaning the water heater, the glass 9 with the electric elements 2 are removed from the housing 1 and the latter is cleaned from the sludge. Elements 2 and cup 9 are undergoing a routine inspection, if necessary cleared of deposits and then easily inserted into the housing 1 in their place. Water heater is ready for operation.
Таким образом, благодар щитку 4 и установке патрубка 3 тангенциально относительно боковой стенки корпуса 1, шлам не забрасываетс на электронагревательные элементы 2, а откладываетс в нижней части корпуса 1. При этом повышаетс надежность водонагревател .Thus, due to the flap 4 and the installation of the nozzle 3 tangentially relative to the side wall of the housing 1, the sludge is not dropped on the electric heating elements 2, but deposited in the lower part of the housing 1. This increases the reliability of the water heater.