(54) УСТАНОВКА ДЛЯ РАЗДАЧИ ЖИДКИХ КОРМОВ(54) INSTALLATION FOR DISTRIBUTING LIQUID FEEDS
рычага 7 камеры 8, смонтированной на напорном трубопроводе 4 выше уровн корма в лакопнтельной емкости / с возможностью перемещеин в .вертикальной плоскости. Установка снабжена насосом 9 .и. лерепуск ,ным трубопроводом 10, .конец которого, расположенный в дозирующей емкости 2, установлен выше верхней точки внутреннего эллипса торца напорного трубопровода 3, .который размбщен выше уро,в.н корма в накопительной емкости. Напорный трубопровод З Оборудован мехадизмом // дл его .перемещени вдоль оси дозирующей емкости . Под сливным устройством установки расположены поильные чаши 12.the lever 7 of the chamber 8 mounted on the pressure pipe 4 above the level of the feed in the container / with the possibility of displacement in the vertical plane. The unit is equipped with a pump 9. And. The pipe, pipe 10, the end of which, located in the dosing tank 2, is installed above the upper point of the internal ellipse of the end of the pressure pipe 3, which is above the level, in the feed in the storage tank. Discharge line C Equipped with mehradism // for its movement along the axis of the dosing container. Under the drain device installation are drinking bowls 12.
Установка работает следующим образом .The installation works as follows.
Перед раздачей напорные трубопроводы 3 посредством механизма устанавливают на необходимую высоту от дна дозирующих емкостей 2, определ ющую дозы жидких кормов, выдаваемые животным. Затем включают насос 9, и жидкий корм из -накопительной емкости ./ по напорным трубопроводам 3 и 4 поступает в камеры 8 и доаирующие емкости 2. В момент заполнени камер 8 вес их увеличиваетс и они, перемеща сь вниз, через рычаги 7 передают усилие на запорные органы 6, которые лерекрывают сливные отверсти патрубков 5, предотвраща утечку жидкого корма из заполн емых дозирующих емкостей. После заполнени последних жидким кормом выше конца перепускного трубопровода 10, жидкий корм начинает поступать по нему в наколительную емкость 1, перемешива наход щийс там жидкий корм, исключа за счет этого выпадание осадка в накопительной емкости.Before dispensing, the pressure pipelines 3 are installed by means of a mechanism to the required height from the bottom of the metering containers 2, which determine the doses of liquid feed given out to animals. Then the pump 9 is turned on, and the liquid feed from the storage tank ./ through the pressure pipelines 3 and 4 enters the chambers 8 and the doarating tanks 2. At the time of filling the chambers 8, their weight increases and they, moving downwards, transfer the force through the levers 7 the locking bodies 6, which close the drain holes of the nozzles 5, preventing the liquid feed from leaking out of the filled dosing tanks. After filling the latter with liquid feed above the end of the overflow pipe 10, the liquid feed begins to flow through it into the kneading tank 1, mixing the liquid feed there, thereby eliminating precipitation in the storage tank.
Дл слива жидкого корма из дозирующнх емкостей 2 в поильные чаши 12 выключают насос 9. В результате этого в напорных трубопроводах 3 н 4 давление ладает и создаетс обратное течение жидкого корма из дозирующих емкостей через насос в накопительную емкость 1 до тех пор, пока уровень жидкого корма в дозирующих емкост х не совпадает с верхней точкой внутренних эллилсов торцов напорных трубопроводов 5 и Б лоследние не попадает воздух. Одновременно происходит опорожнение камер 8, вес их уменьшаетс , что обеспечивает через рычали 7 открытие запорньи органов 6 и слив через патрубки 5 дозирующих емкостей 2 установленных доз жидкого корма в лолльные чаши.To drain the liquid feed from the metering tanks 2 into the drinking bowls 12, turn off the pump 9. As a result, pressure builds up in the pressure pipelines 3 n 4 and the liquid feed flows back from the metering tanks through the pump to the storage tank 1 until the liquid feed level in the metering tanks, it does not coincide with the upper point of the internal aellies of the ends of the pressure pipelines 5 and the latter do not receive air. At the same time, chambers 8 are emptied, their weight is reduced, which ensures, through growling 7, opening of the clogging organs 6 and draining through the nozzles 5 of the dosing containers 2 prescribed doses of liquid feed into lol bowls.
Благодар тому, что торец каждого напорного трубопровода 3 имеет вид эллиптического кольца, верхн точка внутреннегоDue to the fact that the end of each discharge pipe 3 has the form of an elliptical ring, the upper point of the inner
эллипса которого совмещена с осью симметр .ии дозирующей емкости 2, и расположен под угло,м, большим максимально возможного угла а наклона дозирующей емкости в вертикальной плоскости, при мобильной раздаче на негоризонтальных участках пути обеспечиваетс неизменность положени центра зеркала жидкого корма в дозирующей емкости. В св зи с этим отсечка дозы жидкого корма происходит всегда в верхней точке внутреннего эллипса тор.ца напорного трубопровода, что существенно уменьшает вли ние неровностей пути на выдаваемые дозы и повышает точность дозировани .the ellipse of which is aligned with the axis of symmetry of the dosing container 2, and is located at an angle, m, greater than the maximum possible angle a of the dosing capacity in the vertical plane, while mobile dispensing on non-horizontal sections of the path ensures the position of the center of the liquid feed mirror in the dosing container. In this connection, the cut-off of the dose of liquid feed always takes place at the upper point of the internal ellipse of the torus. The pressure pipeline, which significantly reduces the influence of unevenness of the track on the delivered doses and improves the accuracy of dosing.