Гравитационное обогащение полезных минералов, удельный вес которых значительно отличаетс от удельного веса нустой породы, внасто щее врем осуществл етс на шлюзах, концентрационных столах, отсадочных машинах и центробежных пульсаторах. Эффективность работы перечисленных аппаратов (особенно новых отсадочных машин) при средней и мелкой вкрапленности полезного минерала достаточно высока. Эффективность же работы этих аппаратов на руде с очень низкой вкрапленностью полезного минерала сильно снижаетс ввиду больших потерь TOHiKHX зерен полезного минерала в хвостах.The gravitational enrichment of useful minerals, the specific weight of which differs significantly from the specific weight of the bedrock, is currently carried out on gateways, concentration tables, jigging machines and centrifugal pulsators. The efficiency of the above devices (especially new jigging machines) with medium and small impregnation of the useful mineral is quite high. The effectiveness of these devices on ore with a very low impregnation of the useful mineral is greatly reduced due to the large loss of TOHiKHX grains of the useful mineral in the tails.
Особенно велики потери при обогащении олов нных руд, в которых до 40% кассотерита в большинстве случаев состоит из зерен мельче 70 мк. Невозможность извлечени тонких зерен полезного минерала на существующих аппаратах объ сн етс малым весом зерен, вследствие чего они не могут преодолеть в зкость среды ,и опуститьс в нижние слои пульпы. Перечисленные аппараты концентрируют зерна полезного минерала лишь в том случае, если эти зерна могут войти в соприкосновение с нижними сло ми пульпы. Например, при работе на столах извлекаемые зерна должны об зательно соприкасатьс с поверхностью деки, при пользовании шлюзами-с поверхностью ворсистых покровов, располагаемых на дне шлюза, а в случа х применени отсадочных машин с постелью.The losses are especially great in the enrichment of tin ores, in which up to 40% of cassoterite in most cases consists of grains smaller than 70 microns. The impossibility of extracting fine grains of a useful mineral on existing apparatus is explained by the low weight of the grains, as a result of which they cannot overcome the viscosity of the medium and sink into the lower layers of the pulp. These machines concentrate the grains of the useful mineral only if these grains can come into contact with the lower layers of the pulp. For example, when working on tables, recoverable grains must necessarily come into contact with the surface of the deck, when using sluices with the surface of fleecy coats located at the bottom of the sluice, and in cases of using jigging machines with a bed.
Дл эффективного обогащени руд с низкой вкрапленностью полезного м-инерала предлагаетс центробежный пульсатор, в котором действие силы т жести тонких зерен минерала увеличиваетс центробежными силами. Пульсатор, имеющий вид цилиндра, вращающегос на вертикальной оси, отличаетс тем, что цилиндр разделен водопровицаемой перегородкой на два концентричных отделени , из которых внутреннее служит дл передвижени обрабатываемой пульпы, а наружное-дл т , с № 61036- 2 - подвода пульсирующих струи воды к перегородке. Перегородка образована двум перфорированными листами, между которыми помещен р д телескопически перекрывающих друг друга полос с расположеннюй между ,ними сеткой. Это делает перегородку проницаемой дл воды, но .преп тствует прохождению че|рез нее обрабатываемого материала. На фиг. 1 изобр ажен .вертикальный разрез центробежного пульсатора; на фиг. 2-разрез части перегородки в увеличенном масштабе. Вращающийс вертикальный вал / несет на себе цилиндрический барабан 2. Привод вала осуществл етс через щкив 3, заклиненный на валу /. Цилиндрический барабан разделен перегородкой 4 на два концентричных отделени а к в. Первое из них .служит дл подв.ода пульсирующей струи воды к перегородке 4, второе дл передвижени обрабатываемой пульпы. Перегородка 4 водопроницаема и устроена так, что свободно пропускает воду из отделени а в отделение в и преп тствует прохождению твердых частиц из отделени е в отделение а. Это достигаетс благодар особому устройству лерагородки, состо щей из двух перфорированных листов 12 и 13 железа (фиг. 2), между которыMIH помещаетс р д кольцеобразных латунных полос 14, телескопически перекрывающих друг друга. Л|атунные полосы перемещаютс с латунными сет1кам.и 15, имеющими отверсти диаметром 1 мм. Так как полосы и сетки 15 установлены перпендикул рно к нацравлению действи центрОбежной силы, твердые частицы пульпы, прижимаемые к внутреннему листу 12 перегородки 4, до наружного листа 13 не доход т. Дл подвода воды служит труба 6, в которой вращающа с заслонка 5 0беапечИ|Вает прерывность подачи воды в распределительную камеру с, откуда вода по радиальным трубам S поступает в отделение а. В рабочее отделение в пульпа подаетс по трубе 7. Дл отделени концентрата от хвостов при их разгрузке служит кольцевой выступ 9, имеющий форму ножа. Кольцевые желоба 10 и 11 предназ.начены дл приема и отвода: лервый-концентрата, второй-XIBOCTOBПульпа , поступающа в рабочее отделение в вращающегос цилиндрического барабана, действием центробежной силы прижимаетс к водопроницаемой перегородку 4. Вследствие прерывной подачи воды возникает ее пульсаци через перегородку; происходит разрыхление сло материала, образующегос на перегородке, что способствует вытеснению более т желыми частицами полезного минерала частиц пустой породы- Таким образом, пульсаци воды способствует обогащению указанного сло ; зерна полезного минерала концентр.ируютс по всей периферии стейки. Подача пульпы производитс в верхней части барабана, а |разгрузка-в его нижней части. На всем прот жении этого пути отложивщийс на водопроницаемой лерегородке слой подвергаетс многократным перечисткам под действием пульсирующей воды, что способствует высокому извлечению полезного минерала и получению богатого концент1р .ата. Продвижение к разгрузочной ча-сти барабана продуктов обогащени прОИсходит благодар уклону перегородки 4, взаимодействию давлени пульсирующей воды и действию центробежной силы. Давление пульсирующей воды больще давлени , вызываемого ценробежной силой, поэтому в моменты . пульсации зерна минерала оталкив .аютс от водапро.ницаемой перегородки, а с прек|ращением пульации они действием центробежной силы снова прижимаютс к переIn order to effectively enrich the ores with a low impregnation of the useful m-mineral, a centrifugal pulsator is proposed, in which the force of gravity of fine mineral grains is increased by centrifugal forces. The pulsator, having the form of a cylinder rotating on a vertical axis, is characterized in that the cylinder is divided by a water-proof partition into two concentric compartments, of which the inner one serves to move the processed pulp, and the outer one for the processed pulp to septum. The partition is formed by two perforated sheets, between which is placed a row of telescopically overlapping strips with between them, the grid. This makes the partition permeable to water, but prevents the passage of the material being processed through it. FIG. 1 image Agen. Vertical section of a centrifugal pulsator; in fig. 2-section of the partition on an enlarged scale. The rotating vertical shaft (carries the cylindrical drum 2). The shaft is driven through the pin 3, stuck on the shaft /. The cylindrical drum is divided by a partition 4 into two concentric compartments a to c. The first of them serves for the basement of the pulsating jet of water to the partition 4, the second for the movement of the processed pulp. The partition 4 is permeable and arranged so that it freely passes water from the compartment to the compartment and prevents the passage of solid particles from the compartment to the compartment a. This is achieved due to the special arrangement of the timber pillars, consisting of two perforated iron sheets 12 and 13 (Fig. 2), between which the MHH is placed a series of annular brass strips 14, telescopically overlapping each other. L | atunnye stripes are moved with brass mesh sets. And 15, having holes with a diameter of 1 mm. Since the strips and grids 15 are installed perpendicularly to the national action of the center of resilient force, solid pulp particles pressed against the inner sheet 12 of the partition 4 do not reach the outer sheet 13 t. To supply water, there is a pipe 6, in which the rotating valve 5 The interruption of the water supply to the distribution chamber c, from where water through the radial pipes S enters the compartment a. A pipe 7 is fed into the working compartment in the slurry. An annular protrusion 9 having the shape of a knife serves to separate the concentrate from the tails during unloading. The annular chutes 10 and 11 are designed to receive and dispose of: the first concentrate, the second XIBOCTOB pulp, which enters the working compartment in the rotating cylindrical drum, is centrifugally pressed against the permeable wall 4. Due to the discontinuous water supply, it pulses through the wall; loosening of the layer of material formed on the septum occurs, which contributes to the displacement of particles of the waste rock by the heavier particles of the useful mineral. grains of the useful mineral are concentrated all over the periphery of the steaks. The pulp is delivered at the top of the drum, and the unloading at the bottom of the drum. Throughout this route, the layer deposited on the water-permeable park wall undergoes repeated cleaning under the action of pulsating water, which contributes to the high extraction of the useful mineral and the production of a rich concentrate. Advancement of the enrichment products to the discharge part of the drum is due to the slope of the partition 4, the interaction of the pressure of the pulsating water and the action of the centrifugal force. The pressure of the pulsating water is greater than the pressure caused by the centrifugal force, therefore in moments. the pulsations of the grain of the mineral are repelled away from the water-distributing partition, and with the pulsation stopped, with the action of centrifugal force they are again pressed against