11 Изобретение относитс к электроройствам , и может быть использовано дл защиты людей от поражени электрическим током в случае утечки или пробо изол ции на корпус электропотребител , включаемого в электрическую сеть с помощью двухполюсного непол ризованного сетевого разъема. Цель изобретени - повьшение чувствительности устройства. На чертеже представлено предлагае мое устройство. Потребитель электрической энергии 1 содержит обмотку 2 и вкзгючаетс в электрическую сеть с помощью двухполюсного непол ризованного сетевого разъема 3. От выпр мител 4, собранного по мостовой схеме, питаетс выходное реле 5, имеющее размыкающие контакты 6. К вьшр мителю последовательно с катушкой реле подключен тиристор 7. Его управл ющий электрод соединен с коллектором транзистора 8 через резистор 9.. Эмиттер транзистора подключен к клемме Плюс выпр ми тел , а база соединена с металлическим корпусом потребител через высокоомный резистор 10. Устройство дл защитного отключеВИЯ работает следующим образом. При включении потребител в сеть катушка не получает питание, так как тиристор 7 остаётс в закрытом состо нии . Ток через размыкающие контакты 6 проходит по обмотке потребител . В случае пробо изол ции потребител ток проходит от фазного или нулевого прохода через один из диодов вьшр мител , через эмиттер и базу транзистора 8, через высокоомный резистор 10 на металлический корпус потребител 1 а затем через место пробо изол ции и через часть обмотки 2 идет на провод противопо6 ложной пол рности. Транзистор 8 открываетс . Ток с эмиттера переходит на коллектор, затем через резистор 9 поступает на управл ющий электрод тиристора 7 и уходит на клемму Минус выпр мител 4. Происходит открьшание тиристора 7. Катущка получает питание от выпр мител . Реле срабатьшает и разрьшает контакт 6. Потребитель отключаетс от сети. При этом через эмиттер - базу транзистора ток не проходит, и транзистор закрьшаетс . Однако тиристор 7 остаетс открытым, так как через него проходит посто нный ток, величина которого достаточна дл удержани тиристора в открытом состо нии. Поэтому после срабатьюани защиты реле остаетс во включенном положении до тех пор,пока потребитель не выключен с помощью сетевого разъема 3. Предлагаемое устройство защиты отключает электроустановку при пробое изол ции в любой точке обмотки потребител . Защита срабатывает также при малейшем токе утечки на корпус электроприбора.Резистор 10, через которьй корпус потребител соединен с проводами силовой цепи, имеет сопротивление 1,5 МОм. По правилам техники безопасности сопротивление Изол ции электроустановок до 1000 В должно быть не менее 0,5 МОм. Значит сопротивление резистора превьшает норму сопротивлени изол ции в 3 раза. ЕЬли человек прикасаетс одной рукой к заземленной конструкции , а второй - к корпусу электропотребител , имеющего данную схему защиты, то по нему проходит ток (в установках с заземленной нейтралью) меньше одного миллиампера, что вполне безопасно. К тому же защита в этом случае мгновенно сработает и . отключит электроустановку от сети.11 The invention relates to electrical breakdowns, and can be used to protect people from electric shock in the event of leakage or isolation on the case of an electrical consumer plugged into an electrical network using a two-pole, unpolarized network connector. The purpose of the invention is to increase the sensitivity of the device. The drawing shows the proposed my device. The consumer of electrical energy 1 contains a winding 2 and is plugged into an electrical network using a two-pole unpolarized mains connector 3. From the rectifier 4, assembled according to a bridge circuit, an output relay 5 having disconnecting contacts 6 is fed to the thyristor connected in series with the coil of the relay 7. Its control electrode is connected to the collector of transistor 8 through a resistor 9 .. The emitter of the transistor is connected to the Plus terminal with the rectifier body, and the base is connected to the metal case of the consumer through a high-resistance cut 10. Side shielding otklyucheVIYa apparatus operates as follows. When the consumer is turned on in the network, the coil does not receive power, since the thyristor 7 remains in the closed state. The current through the opening contacts 6 passes through the winding of the consumer. In the case of a breakdown of the consumer, the current passes from a phase or zero passage through one of the diodes of the top of the cell, through the emitter and base of the transistor 8, through the high resistance resistor 10 to the metal case of the consumer 1 and then through the sample site and through the winding part 2 goes to counter polarity wire. Transistor 8 opens. The current from the emitter goes to the collector, then through the resistor 9 goes to the control electrode of the thyristor 7 and goes to the Minus terminal of the rectifier 4. The thyristor 7 opens. The coil receives power from the rectifier. The relay triggers and releases contact 6. The consumer is disconnected from the network. At the same time, the current does not pass through the emitter-base of the transistor, and the transistor is closed. However, the thyristor 7 remains open, since a direct current passes through it, the value of which is sufficient to keep the thyristor in the open state. Therefore, after removing the protection, the relay remains in the on position until the consumer is turned off using the network connector 3. The proposed protection device shuts off the electrical installation when the insulation breaks out at any point in the consumer's winding. The protection also operates at the slightest leakage current to the body of the electrical device. The resistor 10, through which the consumer body is connected to the main circuit wires, has a resistance of 1.5 MΩ. According to safety regulations, insulation resistance of electrical installations up to 1000 V must be at least 0.5 MΩ. This means that the resistance of the resistor exceeds the insulation resistance rate by 3 times. If a person touches the grounded structure with one hand and the second to the case of an electrical consumer with this protection circuit, a current (in installations with grounded neutral) is less than one milliampere passing through it, which is quite safe. In addition, the protection in this case will instantly work and. disconnect the electrical installation from the network.