Как известно, процессы мас;;опередачи в трубчатых колоннах проводились на пленочном режиме, когда орошающа жидкость стекает по внутренним стенкам трубок в виде тонкой пленки, на поверхности которой и происходит контактирование фаз. Недостаток такого способа организации процессов массопередачи заключаетс в том, что при этом ие используетс весь объем аппарата {межтрубное пространство).As is well known, the mas ;; processes in tubular columns were carried out in film mode, when the irrigating liquid flows along the inner walls of the tubes in the form of a thin film, on the surface of which the phases contact. The disadvantage of this method of organizing mass transfer processes is that it does not use the entire volume of the apparatus {annulus).
Особенность описываемого способа заключаетс в том, что ипи эмульгационном (пенном) методе массопередачи, проводимой в трубчатых аппаратах, контакт между фазами осуществл етс по всей высоте трубок в слое эмульсии (пены), что приводит к резкому увеличению поверхности соприкосновени между этими фазами и к эффектности разделени - С помощью гидрозатвора высота эмульсии (пены) устаназливаетс несколько выше верхнего уровн трубок, что устран ет необходимость в установке .специального оросител . Трубки в аппарате устанавливаютс плотным пучком и свободно лежат на опорной репетке. При таком способе используетс весь объем трубок, которые при этом служат дл уменьшени перемешивани фаз по высоте аппарата п тем самым приближают процесс массопередачи к противоточному. Все это позвол ет резко снизить высоту трубок.The peculiarity of the described method is that using the emulsifying (foam) method of mass transfer, carried out in tubular apparatuses, the contact between the phases takes place along the entire height of the tubes in the emulsion layer (foam), which leads to a sharp increase in the contact surface between these phases and to effect separation - By means of a water seal, the height of the emulsion (foam) is set slightly higher than the upper level of the tubes, which eliminates the need to install a special sprayer. The tubes in the apparatus are installed in a dense bundle and lie loosely on the support socket. With this method, the entire volume of the tubes is used, which in this case serve to reduce the mixing of the phases along the height of the apparatus and thereby bring the mass transfer process to countercurrent. All this makes it possible to drastically reduce the height of the tubes.
Так как трубки свободно лежат на опорной решетке, то в качестве материала дл изготовлени трубок может быть использовано стекло, фарфор, керамика, пластмасса и др.Since the tubes lie loosely on the supporting grid, glass, porcelain, ceramics, plastic, etc. can be used as the material for the manufacture of tubes.
На чертеже изображена схема трубчатой колонны дл эмульгапионных процессов.The drawing shows a diagram of a tubular column for emulsification processes.
Работа аппарата по предлагаемому способу протекает следуюпи1м образом. Газ (пар) через штуцер /, распределитель 2 и опорную решетку 5 поступает в трубки 4 колонны 5. Пройд трубчатку, в которой осуществл етс контакт между газом и жидкостью, газ уходит из колонны через штуцер 6. Орошающа жидкость подаетс в верхнюю часть колониы по штуцеру 7, проходит трубки и через штуцер 5 и гидрозатвор .9 уходит из колонны. В результате взаимодействи газа (пара) п жидкости во всем объеме трубок образуетс эмульси (пена), высотаThe operation of the apparatus according to the proposed method proceeds in the following way. The gas (vapor) through the choke /, the distributor 2 and the supporting grid 5 enters the tubes 4 of the column 5. Passing the tubular tube in which the contact between the gas and the liquid takes place, the gas leaves the column through the choke 6. The irrigating liquid is supplied to the upper part of the colony fitting 7, passes the tube and through fitting 5 and the hydraulic lock .9 leaves the column. As a result of the interaction of the gas (vapor) and the liquid in the whole volume of the tubes, an emulsion (foam) is formed;