In dem Patent 899 795 ist eine Vorrichtung zum Wärmeaustausch beschrieben,
bei der eine aus Rohrbündeln und mehreren Einzelschüssen bestehende Kolonne aus
gas- und flüssigkeitsdichtem Graphit Verwendung findet, in der der flüssige Anteil
des zu kühlenden bzw. zu erwärmenden Systems durch einen am oberen Ende jedes Einzelschusses
angebrachten Boden und durch schlitzförmige Öffnungen, die an jedem oben verschlossenen,
Kühlerrohr oberhalb dieses Bodens seitlich angebracht sind, über den Querschnitt
jedes einzelnen; Schusses gleichmäßig verteilt wird.In the patent 899 795 a device for heat exchange is described,
in which a column consisting of tube bundles and several individual sections
Gas- and liquid-tight graphite is used in which the liquid part
of the system to be cooled or heated by one at the upper end of each individual shot
attached bottom and through slot-shaped openings, which are closed at the top of each,
The cooler pipe above this bottom are attached laterally over the cross-section
every single one; Shot is evenly distributed.
Es hat sich gezeigt, daß die Absorption der am unteren Ende des Turmes
eintretenden Gase, besonders wenn es sich um konzentrierte Salzsäuregase handelt,
in dem mittleren Teil der Kolonne besonders lebhaft ist, während am unteren Ende,
wo die ablaufende Flüssigkeit bereits aus konzentrierter Säure besteht, sowie am
oberen Ende, wo die Hauptmenge der Salzsäure bereits herausgenommen ist, der Absorptions-
und damit der Kühlvorgang geringere Ausmaße annimmt. Die starke Reaktion in dem
mittleren Teil der Kolonne kann dazu führen, daß durch lokale Wasserdampfbildung
Gaspolster entstehen, die ein unerwünschtes Druckgefälle zwischen dem Eintritts-
und Austrittsende der Gase hervorrufen. Durch Anbringung von Eintritts- und Austrittsstutzen
für das Kühlwasser sowohl am unteren als auch am oberen Ende der Einzelschußkühlermäntel
kann das Kühlwasser im Bedarfsfall in einer für die Kühlwirkung besonders wirksamen
Weise durchgeleitet werden (Abb. i).It has been shown that the absorption of the at the bottom of the tower
incoming gases, especially if they are concentrated hydrochloric acid gases,
is particularly lively in the middle part of the column, while at the lower end,
where the draining liquid already consists of concentrated acid, as well as am
upper end, where most of the hydrochloric acid has already been taken out, of the absorption
and thus the cooling process takes on smaller dimensions. The strong reaction in that
middle part of the column can lead to local water vapor formation
Gas cushions arise, which create an undesirable pressure gradient between the inlet
and cause the gases to exit. By attaching inlet and outlet nozzles
for the cooling water at both the lower and the upper end of the single-shot radiator jackets
If necessary, the cooling water can be particularly effective for the cooling effect
Way (Fig. I).
Es wurde gefunden, daß man den Gaswiderstand und die Wandreibung verringern
und damit den Betrieb der Kolonne ohne Schwierigkeiten durchführen kann, wenn man
den freien Querschnitt der Gesamtheit der Rohre in dem mittleren Teil der Kolonne
durch Wahl von Rohren mit weiterem, vorzugsweise erheblich weiterem Querschnitt
als in den übrigen Teilen der Kolonne heraufsetzt.It has been found that the gas resistance and the wall friction can be reduced
and thus the operation of the column can be carried out without difficulty if one
the free cross-section of all the tubes in the central part of the column
by choosing tubes with a wider, preferably considerably wider, cross-section
than in the rest of the column.
Diese Form einer Wärmeaustauschvorrichtung läßt sich so gestalten,
daß die erfindungsgemäß in der Mitte der Kolonne erfolgende Verwendung weiterer
Rohre mit Rohren kombiniert ist, die am unteren Teil und am oberen Teil der Kolonne
einen untereinander übereinstimmenden engeren Durchmesser haben. Man kann aber auch
im oberen Teil der Kolonne Rohre verwenden, die enger sind und in größerer Zahl
in, den Einzelschüssen enthalten sind als die (weiteren und weniger zahlreichen)
Rohre im unteren Teil der Kolonne. Diese Kombination, die in dem Patent 908488 (Zusatz
zum Patent 899 795) beschrieben ist, hat den Vorteil einer Vergrößerung der Reaktionsfläche
Gas-Flüssigkeit am oberen Ende der Kolonne. Im letzteren Fall läßt sich also die
Folge der Rohrgestaltung von unten nach oben folgendermaßen kennzeichnen: normal,
weit, eng. Für die Zwecke der Salzsäureabsorption hat sich diese Zusammenstellung
als besonders vorteilhaft erwiesen.This form of heat exchange device can be designed so
that according to the invention taking place in the middle of the column use further
Tubes combined with tubes, the lower part and the upper part of the column
have a matching narrower diameter. But you can also
use tubes that are narrower and larger in number in the upper part of the column
in, the individual shots are included as the (more and less numerous)
Pipes in the lower part of the column. This combination, which is described in patent 908488 (addendum
for patent 899 795) has the advantage of enlarging the reaction area
Gas-liquid at the top of the column. In the latter case, the
Mark the pipe design from bottom to top as follows: normal,
wide, narrow. For the purpose of hydrochloric acid absorption, this compilation has been made
Proven to be particularly advantageous.