Einrichtung zur Erweiterung des Regelbereiches eines elektrischen
Reglers . von elektrischen Maschinen Es sind Einrichtungen zur Erweiterung des Regelbereiches
eines elektrischen Reglers von elektrischen Maschinen bekannt, welche neben dem
selbsttätigen Regler einen Widerstand besitzen, welcher entsprechend der Belastung
der Maschine geändert wird. Die Änderung geschieht dabei entweder von Hand oder
durch einen Motor, der in Abhängigkeit von der Belastung in Gang gesetzt wird. Durch
die Einfügung des Widerstandes wird dann ein neuer Zustand geschaffen. Diese Einrichtungen
haben den Nachteil, daß sie infolge der magnetischen Trägheit im Erregerstromkreis
zeitlich stark verzögert arbeiten. Dies wirkt sich besonders nachteilig bei schnell
verlaufenden Spannungsänderungen aus, die bei wechselnder Belastung des Generators
auftreten.Device for expanding the control range of an electrical
Regulator. of electrical machines These are devices for expanding the control range
an electrical controller of electrical machines known, which in addition to the
automatic regulator have a resistance that corresponds to the load
the machine is changed. The change is done either manually or
by a motor that is started depending on the load. By
the insertion of the resistance then creates a new state. These bodies
have the disadvantage that they are due to the magnetic inertia in the excitation circuit
work with a significant delay. This is particularly detrimental to fast
voltage changes that occur when the load on the generator changes
appear.
Die Aufgabe der Erfindung ist es nun, unter Vermeidung der vorstehenden
Nachteile eine vollautomatische Spannungsregelung von Leerlauf bis Vollastbetrieb
zu erreichen und hierbei mit größter Geschwindigkeit von einem auf den anderen Regelbereich
überzugehen. Zu diesem Zweck schlägt die Erfindung vor, den zusätzlichen Widerstand
sprungartig ein- oder auszuschalten.The object of the invention is now to avoid the above
Disadvantages of fully automatic voltage regulation from idle to full load operation
to achieve and thereby with the greatest speed from one to the other control range
to pass over. To this end, the invention proposes the additional resistor
suddenly on or off.
In der Abbildung ist ein Ausführungsbeispiel der Erfindung dargestellt.
In dem Hauptstromkreis der Erregermaschine eines Generators i liegt ein anzapfbarer
Zusatzwiderstand 2, der mittels eines besonderen Schützes 3 über Zwischenrelais
q.a bzw. q. v durch die Kontaktvorrichtung x, y, z am Schnellregler 5 eingeschaltet
bzw. überbrückt wird. Der Schnellregler 5 ist in bekannter Weise nach dem Tirrillsystem
ausgebildet. Er besteht aus zwei Waagebalken 7 und 8, die über Kontakte 6 miteinander
in Verbindung stehen. Auf den Waagebalken 7 wirkt eine von der Spannung der Erregermaschine
i beeinflußte Spule 9 sowie ein Federsystem i o. Auf den Waagebalken 8 wirken die
Spannungssysteme i i sowie ein Gegengewicht 12. Der Waagebalken 8 ist mit Kontakten
x verbunden, die in ihrer Endlage entweder mit den Kontakten y oder mit den Kontakten
z in Berührung kommen und dadurch den Stromkreis der Spule a oder b des Zwischenrelais
q. schließen. Die Kontakte 6 wirken auf die Erregerspulen eines Zwischenrelais 13
ein, dessen Kontakte 14 den im Erregerkreis der Erregermaschine i angeordneten Nebenschlußregler
15 kurzschließen und freigeben. Ein System von Vorwiderständen 16 und 17 gestattet
die Empfindlichkeit der Erregerspulen einzustellen.In the figure, an embodiment of the invention is shown. In the main circuit of the exciter of a generator i there is an additional resistor 2 which can be tapped and which is activated by means of a special contactor 3 via intermediate relays qa or q. v is switched on or bridged by the contact device x, y, z on the rapid regulator 5. The rapid regulator 5 is designed in a known manner according to the Tirrill system. It consists of two balance beams 7 and 8, which are connected to one another via contacts 6. On the balance beam 7 acts a coil 9 influenced by the voltage of the exciter i and a spring system i o. On the balance beam 8, the tension systems ii and a counterweight 12 act. The balance beam 8 is connected to contacts x, which in their end position either with the Contacts y or with the contacts z come into contact and thereby the circuit of the coil a or b of the intermediate relay q. conclude. The contacts 6 act on the excitation coils of an intermediate relay 13, the contacts 14 of which short-circuit and release the shunt regulator 15 arranged in the excitation circuit of the excitation machine i. A system of series resistors 16 and 17 allows the sensitivity of the excitation coils to be adjusted.
Wenn nun der Regler in seiner einen Grenzstellung, die einer geringen
Belastung entspricht, die Kontakte x, y schließt, dann
wird die
Spule b des Zwischenrelais q. erregt und dadurch- die -untere Betätigungsspule des
Schützes 3 -an Spannung gelegt. Diese liält.S das Schütz 3 in der Offenstellung
und brixs damit den Widerstand 2 im Stromkreis == '` "`: Erregermaschine i zur Wirkung.
Die nung an der Erregermaschine wird infolg;@ dessen höher als bei Nichtvorhandensein
des Widerstandes. In diesem Zustand regelt der Regler 5 in bekannter Weise auf konstante
Spannung.If the controller is now in its one limit position, that of a low one
Load corresponds to the contacts x, then y closes
will the
Coil b of the intermediate relay q. energized and thereby- the lower actuating coil of the
Contactor 3 - connected to voltage. This leaves the contactor 3 in the open position
and thus brixs the resistance 2 in the circuit == '`` ``: exciter i to the effect.
As a result, the voltage at the exciter is higher than when it is not available
of resistance. In this state, the controller 5 regulates in a known manner on a constant basis
Tension.
Wenn nun die Belastung im Netz steigt und die Spannung des Generators
dadurch abzusinken droht, dann wird die Spule i i etwas stärker erregt, der Waagebalken
$ wird dadurch im Sinne des Uhrzeigers bewegt, die Kontakte 6 werden infolgedessen
geschlossen und ein Stromkreis hergestellt, der auf das Relais 13 so einwirkt,
daß dessen Kontakte i q. geschlossen werden. Dadurch wird der Widerstand im Nebenschlußkreis
so lange überbrückt, bis die Generatorspannung wieder ihren vollen Wert erreicht
hat. Wenn diesnun nicht gelingt, bewegt sich der Waagebalken 8 immer weiter im Sinne
des Uhrzeigers, bis schließlich die Kontakte x und ä einander berühren. Dies hat
zur Folge, daß die Wicklung a des Zwischenrelais q. erregt; .wird -und über dessen°
Kontakte die obere Wicklung des Schützes 3 Strom erhält. Der Schütz 3 schließt seine
Kontakte und überbrückt- dann den Widerstand 2. Die Folge davon ist, daß der Erregerstrom
und damit die Spannung des Generators i ansteigt und der von der Netzspannung in
Gegenwirkung zum Belastungsstrom beeinflußte Hebel 8 in der Uhrzeigerbewegung entgegengesetzter
hichtung bewegt und der-Kontakt x vom y4 * -@I?ntakt z wieder abgehoben wird.
Der Regler ah t.If the load in the network increases and the voltage of the generator threatens to decrease, then the coil ii is excited a little more, the balance arm $ is thereby moved in the direction of the clock, the contacts 6 are consequently closed and a circuit is established that on the Relay 13 acts so that its contacts i q. getting closed. This bridges the resistance in the shunt circuit until the generator voltage has reached its full value again. If this does not succeed, the balance beam 8 continues to move in the clockwise direction until finally the contacts x and ä touch one another. This has the consequence that the winding a of the intermediate relay q. excited; .will -and through whose ° contacts the upper winding of the contactor 3 receives current. The contactor 3 closes its contacts and then bridges the resistor 2. The consequence of this is that the excitation current and thus the voltage of the generator i increases and the lever 8, which is influenced by the mains voltage in counteraction to the load current, moves clockwise in the opposite direction and the - Contact x is lifted off again from y4 * - @ I? Ntakt z. The controller ah t.
YY #v >mag nun wieder auf konstante Spannung die Maschine einzuregulieren.
Dies dauert so lange, bis die Kontakte x, y wieder in Berührung kommen *und dadurch
der Widerstand 2 wieder eingeschaltet wird. Die Wirkung läuft also darauf hinaus,
daß der Regler seinen Bereich einmal mit überbrücktem und einmal mit eingeschaltetem
Widerstand.-durchläuft, so daß er nur die Hälfte seines Betätigungsbereiches zu
haben braucht, als wenn der Widerstand 2 nicht vorhanden wäre.YY #v> likes to regulate the machine again to constant voltage.
This lasts until the contacts x, y come into contact again * and thereby
the resistor 2 is switched on again. So the effect boils down to
that the controller has its range once with bridged and once with switched on
Resistance.-passes through so that it is only half of its operating range
need to have as if the resistor 2 were not present.