<Desc/Clms Page number 1>
EMI1.1
EMI1.2
<Desc/Clms Page number 2>
Kanäle o, p, q,'r, 8 angeordnet sind, in welche Gas und Luft in solcher Verteilung eingeführt wird, dass eine vollständige Verbrennung und damit die grösste Hitzeentwicklung erst in der Nähe der Ausstossiffnung geschieht. a und b sind die an der Ausstossseite B, c und d die an der Einsatzseite A befindlichen Luftbzw. Gaskanäle, welche mit den Regenerativkammern e,/', g, h in Verbindung stehen. Die Kanäle a
EMI2.1
und G2 sind in den Herd verlegt.
Die Heizzüge o, p, q, r, s sind bei dem an der Einsatzseite befindlichen Brenner G2 mit Gewölben on abgedeckt, so dass die Blöcke erst nach einer gewissen Anwärmung mit den Heizgasen in Berührung kommen. Die Gas-und Luftzufuhr an dieser Stelle ist so ausgebildet, dass eine vollkommene Verbrennung des Gas- und Luitgemisches erst dann eintreten kann, wenn es schon einen gewissen Weg im Ofen zurückgelegt hat, wodurch erreicht wird, dass der Höchstwert der Erhitzung stets an der gleichen Stelle, und zwar in der Nähe der Ausstossöffnung B,
EMI2.2
dass sie vor dem Gewölbe n bei k unterhalb der Stossbahn v einmünden.
Die Wirkungsweise des Ofens ist folgende :
Die vom Brenner G1 austretenden Gase umspülen zunächst die der Ausstossöffnung B am nächsten gelegenen, bereits stark angewärmten Blöcke m und erteilen diesen die höchste
EMI2.3
abziehen. Nach Änderung der Flammenrichtung treten Luft und Gas durch die Kanäle c und d in den durch das Gewölbe n gegen die Stossbahu abgedeckten Raum ein, der durch die Unter-
EMI2.4
Die sich bildende Schlacke wird durch die Kanäle u und < abgezogen.
Bei dem in Fig. 3 und 4 dargestellten Ofen schliesst sich an die Stossbahn r ein Rollherd ? an, bei welchem also die Blöcke rn allmählich zur Ausstossöffnung B gerollt werden. Diese befindet sich bei dieser Ausführungsform seitlich ; l sind seitliche Arbeitsöfinuilgen, durch welche
EMI2.5
und l seitlich liegen, so braucht auch nur an einer Seite der Brenner zu in den Herd verlegt zu werden. Die in die seitlichen Kanäle o und s mündenden Brenner 6*3 werden hiebei ganz oder
EMI2.6
von den Stirnwänden aus nicht behindert wird.
Die Entwicklung der höchsten Hitzegrade in der Nähe der Ausstossöffnung kann auch dadurch gesichert werden, dass man eine grosse Anzahl von Gas- und Luftbrennern entsprechend verteilt in dem Herd und in den Seitenwänden des Ofens anbringt.
PATENT ANSPRÜCHE :
EMI2.7
parallel oder annähernd parallel bleibt.
<Desc / Clms Page number 1>
EMI1.1
EMI1.2
<Desc / Clms Page number 2>
Channels o, p, q, 'r, 8 are arranged, in which gas and air is introduced in such a distribution that complete combustion and thus the greatest heat development only occurs in the vicinity of the discharge opening. a and b are the air or air on the discharge side B, c and d are the air or air on the insert side A. Gas channels which are connected to the regenerative chambers e, / ', g, h. The channels a
EMI2.1
and G2 are relocated to the stove.
The heating flues o, p, q, r, s are covered with vaults on the burner G2 located on the insert side, so that the blocks only come into contact with the heating gases after a certain amount of warming. The gas and air supply at this point is designed so that a complete combustion of the gas and Luit mixture can only occur when it has already covered a certain distance in the furnace, which means that the maximum value of the heating is always the same Place, in the vicinity of the discharge opening B,
EMI2.2
that they open in front of the vault n at k below the butt path v.
The stove works as follows:
The gases emerging from the burner G1 initially wash around the already strongly warmed blocks m, which are closest to the discharge opening B, and give them the highest
EMI2.3
pull off. After changing the direction of the flame, air and gas enter through channels c and d into the space covered by the vault n against the stossbahu, which is
EMI2.4
The slag that forms is drawn off through channels u and <.
In the furnace shown in FIGS. 3 and 4, a roller hearth adjoins the ridge r? at which the blocks rn are gradually rolled towards the discharge opening B. This is on the side in this embodiment; l are side work openings through which
EMI2.5
and l are to the side, the burner only needs to be moved into the stove on one side. The burners 6 * 3 opening into the lateral channels o and s become whole or
EMI2.6
is not obstructed by the end walls.
The development of the highest degrees of heat in the vicinity of the discharge opening can also be ensured by installing a large number of gas and air burners appropriately distributed in the hearth and in the side walls of the oven.
PATENT CLAIMS:
EMI2.7
remains parallel or approximately parallel.