<Desc/Clms Page number 1>
EMI1.1
EMI1.2
EMI1.3
<Desc/Clms Page number 2>
Die verdichtete Luft wird während des Übertrittes aus dem Niederdruckraume 7 nach dem Hochdruckraums 8 gemäss der Linie b#c des Diagrammes weiter verdichtet, wobei die Verdichtung eines grossen Teiles des Gases innerhalb des Röhrenbündels 11 stattfindet, so dass die entstehende Verdichtungswärme von dem Kühlwasser sofort aufgenommen und mit diesem durch den Stutzen 17 abgeführt wird.
Die bereits abgekühlte, im Hochdruckraume 8 befindliche verdichtete Luft wird nun beim folgenden Hube des Stufenkolbens 4, 5 aus seiner linken Endstellung nach rechts nach der Linie c#g des Diagrammes noch weiter verdichtet. Bei dieser Verdichtung steht das Gas zum grössten Teile abermals unter der Einwirkung des Röhrenbündels 11, da es durch den Stufenkolben in das Röhrenbündel hineingedrückt wird, bis es nach Erreichung des Druckes im Punkt g.
EMI2.1
Linie g#f ausgestossen wird. Die während dieses Verdichtungsvorganges entstehende Wärme wird daher zum grössten Teile ebenfalls durch das Röhrenbündel 11 aufgenommen und mit dem Kühlwasser abgeleitet.
Infolge der Anordnung des Druckorganes 14 des Hochdruckraumes 8 an der dem Nieder-
EMI2.2
die Wärme während der Dauer der Verdichtung abgeführt, sondern auch nach Öffnung des Druckventils 14 wird noch eine gewisse Wärmemenge der verdichteten Luft durch das Röhrenbündel 11 entzogen, da die ganze austretende Luftmenge gezwungen ist. durch das Röhrenbündel hindurch- zutreten.
Das Ventil 14 kann auch im Raum 15 untergebracht sein (Fig. 3). Auch in diesem Falle findet eine Kühlung der Luft durch den Kühler 11 sowohl während des Oberströmens als auch während der ganzen Dauer des Verdichtungsvorganges im Hochdruckraume statt. Ein Nachkühlen der austretenden Luft ist jedoch hiebei nicht mehr vorhanden.
PATENT-ANSPRÜCHE :
EMI2.3
<Desc / Clms Page number 1>
EMI1.1
EMI1.2
EMI1.3
<Desc / Clms Page number 2>
The compressed air is further compressed during the passage from the low-pressure space 7 to the high-pressure space 8 according to the line b # c of the diagram, whereby the compression of a large part of the gas takes place within the tube bundle 11, so that the resulting compression heat is immediately absorbed by the cooling water and is discharged with this through the nozzle 17.
The already cooled, compressed air located in the high-pressure space 8 is now compressed even further during the following stroke of the stepped piston 4, 5 from its left end position to the right according to the line c # g of the diagram. During this compression, the gas is again for the most part under the action of the tube bundle 11, since it is pressed into the tube bundle by the stepped piston until it, after reaching the pressure at point g.
EMI2.1
Line g # f is ejected. The heat generated during this compression process is therefore for the most part also absorbed by the tube bundle 11 and dissipated with the cooling water.
As a result of the arrangement of the pressure element 14 of the high pressure chamber 8 on the
EMI2.2
the heat is dissipated during the duration of the compression, but also after the pressure valve 14 is opened, a certain amount of heat is still withdrawn from the compressed air through the tube bundle 11, since the entire amount of air exiting is forced. to pass through the tube bundle.
The valve 14 can also be accommodated in the space 15 (FIG. 3). In this case, too, the air is cooled by the cooler 11 both during the overflow and during the entire duration of the compression process in the high-pressure space. However, there is no longer any subsequent cooling of the exiting air.
PATENT CLAIMS:
EMI2.3