<Desc/Clms Page number 1>
Einrichtung zum Anlassen von Drehstrommotoren mittels als Autotransformatoren ausgebildeter Anlasstransformatoren.
Das An fassen von Drehstrommotoren mittels Anlasstransformator erfolgte bisher in der Weise, dass zunächst die Spannung am Motor plötzlich oder in mehreren Stufen auf
EMI1.1
volle Umdrehungszahl erhält. Nachdem letztere erreicht ist, kann plötzlich oder wieder in mehreren Stufen die Spannung auf den Normalwert erhöht werden. Die Fig. 1 bis 3 geben
EMI1.2
t der als Autotransformator ausgebildete Transformator. Bei Fig. 1 ist ausgeschaltet ; Fig. 2 zeigt die Schaltung für den Anlauf, Fig. 3 diejenige für den Betrieb. Das Überschalten
EMI1.3
kurve die Einschaltung erfolgt, da der Motor seine Maguetisierung durch die Strom- unterbrechung mehr oder weniger gänzlich verliert.
Im zweiten Falle wird der Apparat kompliziert und teuer, indem bei nur einer Stufe die Drosselspule gross wird, hei mehreren Stufen dagegen die Drosselpule zwar kleiner ausgeführt werden kann, aber der Schalter eine grosse Zahl von Kontakten erhalten muss.
EMI1.4
weise des leerlaufenden, nun beinahe auf volle Tourenzahl genommenen Motors auf ungefähreinVierteldesdernormalenVollbelastungentsprechendenBetrageszurückgegangen ist. Hurch geeignete Dimensionierung des Transformators : tsst sich sogar ohne Schwierigkeit erzielen, dass die Motorapunnung beim Öffnen der Neutraien ansteigt, z. H. auf 75 v. II. der Gesamtspannung:
man muss in diesem Fall den Transformator so wählen, dass seine
EMI1.5
<Desc/Clms Page number 2>
EMI2.1
2. Anlauf mit ungefähr halber'Spannung (Fig. 5),
3. Auflösen der Neutralen (Fig. 6),
4. Kurzschliessen des Anlasstransformators (Fig. 7).
Es ist jedoch nicht notwendig, die Stellung 3 als besondere Stufe auszubilden, es genügt vielmehr, wenn diese Schaltung beim Übergehen von Stellung 2 auf während eines kurzen Augenblicks vorhanden ist. Andererseits kann zum Schlusse als dauernde Betriebsschaltung eine weitere Stellung (Fig. 8) hinzugefügt sein, in welcher der Aulasstransformator vollständig abgetrennt und daher spannungslos ist. In der Ausschaltstellung (Fig. 4) kann die Neutrale wie bei Fig. 6 ff. geöffnet sein, sie könnte jedoch auch wie bei Fig. i geschlossen sein.
PATENT-ANSRPÜCHE:
1. Einrichtung zum Anlassen von Drehstrommotoren mittels a1s Autotransformatoron ausgchildeter Anlasstransformatoren, dadurch gekennzeichnet, dass nach dem Anlaufen des Motors mit ungefähr halber Spannung zuerst die Neutrale des Anlasstransformators geöffnet und darauf die ganze Wicklung-gegebenenfalls mittels Widerstände - kurzgeschlossen wird, zu dem Zwecke, die beim plötzlichen Überschatten auf die volle Spannung auftretenden Stromstösse zu vermeiden.
<Desc / Clms Page number 1>
Device for starting three-phase motors by means of starting transformers designed as autotransformers.
Up to now, three-phase motors have been touched using a starting transformer in such a way that the voltage on the motor is initially applied suddenly or in several stages
EMI1.1
gets full speed. After the latter has been reached, the voltage can be increased to the normal value suddenly or again in several stages. Figures 1 to 3 give
EMI1.2
t the transformer designed as an autotransformer. In Fig. 1 is off; Fig. 2 shows the circuit for start-up, Fig. 3 that for operation. The over-shifting
EMI1.3
curve the switch-on takes place because the motor more or less completely loses its magnetization due to the power interruption.
In the second case, the apparatus becomes complicated and expensive, in that the choke coil becomes large with only one stage, whereas with several stages the choke coil can be made smaller, but the switch must have a large number of contacts.
EMI1.4
wise, the idling engine, which is now almost at full number of revolutions, has decreased to approximately a quarter of the amount corresponding to the normal full load. By appropriately dimensioning the transformer: it can even be achieved without difficulty that the motor voltage increases when the neutrals are opened, e.g. H. to 75 v. II. The total voltage:
in this case you have to choose the transformer so that its
EMI1.5
<Desc / Clms Page number 2>
EMI2.1
2. Start-up with approximately half the voltage (Fig. 5),
3. Dissolving the neutrals (Fig. 6),
4. Short-circuit the starting transformer (Fig. 7).
It is not necessary, however, to design position 3 as a special stage; it is rather sufficient if this switching is present for a brief moment when moving from position 2 to. On the other hand, a further position (Fig. 8) can be added at the end as a permanent operating circuit, in which the output transformer is completely disconnected and therefore de-energized. In the switch-off position (FIG. 4), the neutral can be open as in FIG. 6 ff., But it could also be closed as in FIG.
PATENT CLAIMS:
1. Device for starting three-phase motors by means of a1s autotransformeron, characterized in that after the motor has started with approximately half the voltage, the neutral of the starting transformer is first opened and then the entire winding is short-circuited - possibly by means of resistors - for the purpose that to avoid current surges occurring in the event of a sudden overshadowing to full voltage.