<Desc/Clms Page number 1>
EMI1.1
EMI1.2
EMI1.3
<Desc/Clms Page number 2>
EMI2.1
da er sich ja-abgesehen von seiner phasenverschiebenden Wirkung - bei Strömen, deren Spannung und Richtung beständig wechselt, tatsächlich wie ein geschlossener Leiter mit konstantem Widerstand verhält.) Erst wenn die Spannung der ansteigenden Stromkurve so hoch geworden ist, dass sie diejenige des Sammlers überwindet, tritt eine Vermehrung der auf die Anziehung hinwirkenden Kraftlinien und mit ihr der Kontaktschluss des Hauptstromes ein, worauf der Strom des verbleibenden Stromkurvcnabschnittes so lange in die Batterie Hiesst, bis die abnehmende Spannung der fallenden Stromkurve sich der Klemmen- spannung wieder nähert.
Diese Ausführungsform stellt das Schaltungsschema Fig. 1 dar, wobei bemerkt wird, dass ein nach dieser Anordnung gebauter Apparat nur innerhalb gewisser Grenzen ordnungs- gemäss arbeitet und hiezu das Vorhandensein eines relativ hohen Ladewiderstandes Vor-
EMI2.2
d den bei e schwingenden Anker, f den Arbeitskontakt, g die auf den Anker wirkende Feder und A einen Vorschaltwiderstand. Der Hauptstromkrois führt durch Draht 1, Widerstand h, Draht 2, Kontakt f, Anker d und Draht 3 zur Batterie b, durch Draht 4 zur Stromquelle zurück. Der Nebenschlusswcg wird durch die Drähte 1 und 5, die Spule ;, Draht 6, den Kondensator A', die Drähte 7 und 3, Batterie b und Draht 4 gebildet.
Feder g wird so eingestellt, dass sie die Anziehungskraft des Magneten c eben überwindet.
EMI2.3
Regelungswiderstandes n gebildeten. von der einen Klemme des Sammlers zur anderen führenden Stromweg eingeschaltet. Die Schaltung ist derart angrordnet, dass die Wicklung iii
EMI2.4
In allen diesen Fällen kann der Magnet c durch einen von der Sammolbatterie gespeistenElektromagnetenersetztwerden.
Auch bei der Ausführungsform nach Fig. und 5 wird ein von den Batterieklemmen entnommener, die Gegeninduktion bewirkender Strom in einer zweiten Wicklung wirksam.
EMI2.5
auf den Schenkeln eines polarisierten Wechselstrommagneten angebracht, zwischen dessen I'olen der Anker schwingt, s ist ein Stahlmagnet, mit dessen Nordpol N das hufeisen- @ förmige Weicheisenstück t verbunden ist : ersteres zeigt folglich in beiden Schenkeln Nord- magnetismus. Mit dem Südpol S des Stahlmagnets ist bei e der Anker d verbunden, welcher
EMI2.6
<Desc/Clms Page number 3>
EMI3.1
Draht 2, Schwingungsachse e, Anker d, Kontakt f, Draht 3, Batterie b und Draht 4 gebildet wird.
Der Augenblick des Kontaktschlusses und die Annahme der vollständigen Umpolarisicrung des zweiten Magnetschenkels ist der Darstellung in Fig. 4 zugrunde gelegt. Die der Gegeninduktion dienenden Wicklungen w werden auf dem von den Drähten 3 und 9, der ersten Wicklung tp, dem Draht 10, der zweiten Wicklung ', dem Draht 11, dem Regelungswiderstand v und den Drähten 12 und 4 gebildeten Wege mit dem Gleichstrom versehen und sind diese Wicklungne w natürlich derart, dass die von ihnen ausge- übte Induktion derjenigen der Wicklungen i (entgegenwirkt.
EMI3.2
hervorgeht, zwei oder mehrere in ihrer Drohung voneinander abhängige Anker mit demselben Magneten und besonderen Kontakten zusammenwirken. Dasselbe ist natürlich auch bei den anderen Ausführungsformen möglich.
Dadurch wird nicht allein die spezifische Belastung der Kontaktflächen vermindert, sondern auch in zweckmässiger Weise die ver-
EMI3.3
PATENT-ANSPRÜCHE :
1. Vorrichtung zum Entnehmen von Gleichstrom aus einer Wechselstromquelle durch einen unter dem Einfluss einer im Nebenschluss zur Wechselstromquelle geschalteten Spule synchron schwingenden, einen Kontakt im Hauptschluss steuernden Unterbrecher, dadurch gekennzeichnet, dass auf den synchron schwingenden Anker (d) die Spannung einer mit der Vorrichtung verbundenen Sammelbatterie (b) derart einwirkt, dans sie der Vermehrung der auf Stromschluss im lIauptstromkreis hinwirkenden Kraftlinien bei dem zur Ladung benutzten Stromstoss entgegenwirkt, so dass der Stromschtuss nur durch den Spannungs-
EMI3.4
<Desc / Clms Page number 1>
EMI1.1
EMI1.2
EMI1.3
<Desc / Clms Page number 2>
EMI2.1
because - apart from its phase-shifting effect - it actually behaves like a closed conductor with constant resistance for currents whose voltage and direction are constantly changing.) Only when the voltage of the rising current curve has become so high that it overcomes that of the collector An increase in the lines of force acting on the attraction occurs and with it the contact closure of the main current, whereupon the current of the remaining current curve section flows into the battery until the decreasing voltage of the falling current curve approaches the terminal voltage again.
This embodiment shows the circuit diagram of FIG. 1, whereby it should be noted that an apparatus built according to this arrangement only works properly within certain limits and, for this purpose, the presence of a relatively high charging resistor.
EMI2.2
d the armature oscillating at e, f the normally open contact, g the spring acting on the armature and A a series resistor. The main current loop leads through wire 1, resistor h, wire 2, contact f, armature d and wire 3 to battery b, through wire 4 back to the power source. The shunt circuit is formed by wires 1 and 5, coil;, wire 6, capacitor A ', wires 7 and 3, battery b and wire 4.
Spring g is adjusted so that it overcomes the attraction of magnet c.
EMI2.3
Regulating resistor n formed. switched on from one terminal of the collector to the other leading current path. The circuit is arranged in such a way that the winding iii
EMI2.4
In all of these cases, the magnet c can be replaced by an electromagnet powered by the collecting battery.
Also in the embodiment according to FIGS. 1 and 5, a current taken from the battery terminals and causing the mutual induction is effective in a second winding.
EMI2.5
attached to the legs of a polarized alternating current magnet, between whose poles the armature swings, s is a steel magnet, with the north pole N of which the horseshoe-shaped piece of soft iron t is connected: the former consequently shows north magnetism in both legs. The armature d is connected to the south pole S of the steel magnet at e, which
EMI2.6
<Desc / Clms Page number 3>
EMI3.1
Wire 2, oscillation axis e, anchor d, contact f, wire 3, battery b and wire 4 is formed.
The illustration in FIG. 4 is based on the instant of contact closure and the assumption of complete polarization reversal of the second magnet leg. The windings w serving for mutual induction are provided with the direct current on the path formed by the wires 3 and 9, the first winding tp, the wire 10, the second winding ', the wire 11, the regulating resistor v and the wires 12 and 4 these windings ne w are of course such that the induction they exert counteracts that of windings i (.
EMI3.2
it emerges that two or more anchors, which are dependent on one another in their threat, interact with the same magnet and special contacts. The same is of course also possible with the other embodiments.
This not only reduces the specific load on the contact surfaces, but also expediently reduces the
EMI3.3
PATENT CLAIMS:
1. Device for drawing direct current from an alternating current source through a synchronous oscillating under the influence of a coil connected in the shunt to the alternating current source, a contact in the main circuit controlling breaker, characterized in that on the synchronously oscillating armature (d) the voltage of a with the device connected accumulator battery (b) acts in such a way that it counteracts the increase in the lines of force acting on the current circuit in the main circuit during the current surge used for charging, so that the current surge is only caused by the voltage
EMI3.4