<Desc/Clms Page number 1>
Empfangsanordnung für elektrische Wellen.
Versuche haben gezeigt, dass die Empfangsergebnisse sich besonders günstig gestalten, wenn die Empfangsantenne möglichst ohne Benutzung einer Verlängerung in ihrer Eigenschwingung verwendet wird, wobei vorausgesetzt ist. dass die Empfangsantenne aus einem senkrecht aufsteigenden Draht ohne Endkapazität besteht. Wenn es praktisch nicht möglich ist, die Empfangsantenne ohne irgendwelche Verlängerung durch Selbstinduktion an den Empfangskreis anzukoppeln, so ist es notwendig, die sich dabei ergebende, durch die Ankopplung bedingte Selbstinduktion wiederum durch einen Kondensator aufzuheben.
Es hat sich weiter gezeigt, dass auch Empfangsantennen, die nicht in ihrer Grundwelle, sondern in einer Oberwelle erregt werden, in gleicher Weise günstigen Einfluss auf den Empfang ausüben. wenn nur die durch Ankopplung des Empfängers bedingte Verlängerung oder Verkürzung der Antenne durch Einschaltung eines entsprechenden Wechselstromwiderstandes wieder kompensiert wird.
Bei den bisherigen Anordnungen diente die eingeschaltete Spule oder der eingeschaltete Kondensator zur Abstimmung der Antenne. Selbst die grösste der geometrischen Längen war eine solche, dass ihre Eigenschwingung von der Empfangsschwingung wesentlich verschieden war und erst durch das eingeschaltete Mittel die Abstimmung resultierte. Es musste dann das eingeschaltete Mittel so bemessen werden, dass der gesamte induktive Widerstand der Antenne (geometrische Länge und eingeschaltetes Mittel) dem gesamten kapazitiven Widerstand entspricht. Gemäss der Erfindung wird aber der zusätzliche Wechselstromwiederstand nur so gross gemacht, dass er den Wechselwiderstand des Kopplungselementes allein kompensiert, ohne dass die Antenne dabei berücksichtigt wird. Ist z.
B. die Kopplung mittels einer Spule erfolgt, so muss der zusätzliche Kondensator so gross sein, dass er den induktiven Widerstand nur dieser Spule aufhebt, während gleichzeitig die Abstimmung auf die Empfangswelle durch die Länge der Antenne selbst bedingt ist. also nicht durch die mittels des Kopplungselementes verlängerte oder verkürzte Antennenlänge. Es ist also einerseits die geometrische Antennenlänge in Resonanz mit der Empfangswelle und anderseits ist die Kombination von Kopplungsspule und Kondensator ebenfalls in Resonanz. Es wird dadurch erreicht, dass an der Serienschaltung Kondensator und Kopplungsspule keine Spannungsdifferenz besteht und diese übt daher keinen Einfluss auf die Abstimmung der Antenne aus.
**WARNUNG** Ende DESC Feld kannt Anfang CLMS uberlappen**.
<Desc / Clms Page number 1>
Receiving arrangement for electric waves.
Tests have shown that the reception results are particularly favorable if the receiving antenna is used in its natural oscillation without using an extension, which is a prerequisite. that the receiving antenna consists of a vertically ascending wire with no end capacitance. If it is practically impossible to couple the receiving antenna to the receiving circuit by self-induction without any extension, it is necessary to cancel the self-induction caused by the coupling again by a capacitor.
It has also been shown that receiving antennas which are excited not in their fundamental wave but in a harmonic have an equally favorable influence on reception. if only the extension or shortening of the antenna caused by the coupling of the receiver is compensated for by switching on a corresponding alternating current resistor.
In the previous arrangements, the switched-on coil or the switched-on capacitor was used to tune the antenna. Even the largest of the geometrical lengths was such that its natural oscillation was significantly different from the received oscillation and the coordination only resulted when the device was switched on. The activated means then had to be dimensioned in such a way that the total inductive resistance of the antenna (geometric length and activated mean) corresponds to the total capacitive resistance. According to the invention, however, the additional alternating current resistance is only made so large that it compensates for the alternating resistance of the coupling element alone, without taking the antenna into account. Is z.
B. the coupling takes place by means of a coil, the additional capacitor must be so large that it cancels the inductive resistance of only this coil, while at the same time the tuning to the receive wave is determined by the length of the antenna itself. thus not due to the antenna length which is lengthened or shortened by means of the coupling element. So on the one hand the geometrical antenna length is in resonance with the received wave and on the other hand the combination of coupling coil and capacitor is also in resonance. The result is that there is no voltage difference between the capacitor and the coupling coil in series, and this therefore has no influence on the tuning of the antenna.
** WARNING ** End of DESC field may overlap beginning of CLMS **.