Paul Start

The critical stress to break flocs of multiwalled-carbon anotubes suspended in low-molecular-weight polymer fluid is measured in planar elongational flow. Through image analysis of aggregates and their fragments, the extension rate of the flow and the size and aspect ratio of the aggregates are measured in real time. While trapping an aggregate at the stagnation point of the device, the flow rate is increased continually and breaking events are recorded, establishing a correlation between aggregate size and the critical elongation stress for fragmentation σ. This relationship resembles that for the breakup of flocs comprising spherical particles, yet it indicates that the strength of these fibrous flocs depends much more strongly on the local particle concentration. Fracture avalanches (or cascades) are also observed.

The primary application for CNT composites is the enhancement of their electrical properties relative to pure polymers. The conductivity is controlled by the alignment and the dispersion of the nanotubes in the polymer matrix during processing. Understanding the interplay between conductivity, processing, alignment and rheology is key their efficient use. We present simultaneous measurements of the Rheology and conductivity of

The critical stress to break flocs of multiwalled-carbon nanotubes suspended in low-molecular-weight polymer fluid is measured in planar elongational flow. Through image analysis of aggregates and their fragments, the extension rate of the flow and the size and aspect ratio of the aggregates are measured in real time. While trapping an aggregate at the stagnation point of the device, the flow rate is increased continually and breaking events are recorded, establishing a correlation between aggregate size and the critical elongation stress for fragmentation sigma. This relationship resembles that for the breakup of flocs comprising spherical particles, yet it indicates that the strength of these fibrous flocs depends much more strongly on the local particle concentration. Fracture avalanches (or cascades) are also observed.

... glycol; PTMG, polytetramethylene glycol; BD, 1,4-butanediol; DA, 2,4-hexadiyene-1,6-diol; TMP, trimethylol propane; 1,4-CHDM, 1,4-cyclohexane dimethanol; BEP, 2-butyl 2-ethyl 1,3 propanediol; DIE, 2,2-dimethyl 1,3 propanediol; MOCA, methylene bisorthochloroaniline ...

The influence of toughener and clay concentration on the morphology and mechanical properties of three-phase, rubber-modified epoxy nanocomposites was studied. Nanocomposite samples were prepared by adding octadecyl ammonium ion exchanged clay to a dispersion of pre-formed acrylic rubber particles in liquid epoxy, so as to minimize alteration to the rubber morphology in the final cured specimen. The state of clay platelet exfoliation and rubber dispersion in the cured nanocomposites was studied using transmission electron microscopy. The amounts of clay platelet separation and dispersion of clay aggregates in the epoxy matrix were found to be sensitive to clay and toughener concentration, and clay platelets preferentially adsorb to the rubber particles. Tensile modulus and strength increase and ductility decreases with increasing organoclay content, while rubber has the opposite effects on the properties of epoxy resin. When both additives are present in epoxy resin, a favorable combination is produced: ductility is enhanced without compromising modulus and strength. Modulus and strength are improved by nano and micro dispersion of nanoclay in the epoxy matrix, whereas elongation and toughness are improved by clay adsorption to the rubber particle surface, which promotes cavitation. The glass transition temperature of epoxy resin remains relatively unchanged with clay addition.