samply is a command line CPU profiler which uses the Firefox profiler as its UI.
At the moment it runs on macOS and Linux. Windows support is planned. samply is still under development and far from finished, but works quite well already.
Give it a try:
% cargo install samply
% samply record ./your-command your-arguments
This spawns ./your-command your-arguments in a subprocess and records a profile of its execution. When the command finishes, samply opens
profiler.firefox.com in your default browser, loads the recorded profile in it, and starts a local webserver which serves symbol information and source code.
Then you can inspect the profile. And you can upload it.
Here's an example: https://share.firefox.dev/3j3PJoK
This is a profile of dump_syms, running on macOS, recorded as follows:
samply record ./dump_syms ~/mold-opt-libxul.so > /dev/null
You can see which functions were running for how long. You can see flame graphs and timelines. You can double-click functions in the call tree to open the source view, and see which lines of code were sampled how many times.
All data is kept locally (on disk and in RAM) until you choose to upload your profile.
samply is a sampling profiler and collects stack traces, per thread, at some sampling interval (the default 1000Hz, i.e. 1ms). On macOS, both on- and off-cpu samples are collected (so you can see under which stack you were blocking on a lock, for example). On Linux, only on-cpu samples are collected at the moment.
On Linux, samply needs access to performance events system for unprivileged users. For this, you can either:
-
if using Linux 5.8 or later, set the
CAP_PERFMONcapability as effective and permitted for samply (recommended):sudo setcap 'cap_perfmon+ep' `which samply` -
allow use of (almost) all events by changing the
perf_event_paranoidkernel variable (not recommended):sudo sysctl kernel.perf_event_paranoid=-1
If you still get a mmap failed error (an EPERM), you might also need to increase the mlock limit, e.g.:
sudo sysctl kernel.perf_event_mlock_kb=2048
Here's a profile from samply record rustup check: https://share.firefox.dev/3hteKZZ
I'll add some Linux examples when I get a chance.
If you profile Rust code, make sure to profile a binary which was compiled in release mode and with debug info. This will give you inline stacks and a working source code view.
The best way is the following:
- Create a global cargo profile called
profiling, see below how. - Compile with
cargo build --profile profiling. - Record with
samply record ./target/profiling/yourrustprogram.
To create the profiling cargo profile, create a text file at ~/.cargo/config.toml with the following content:
[profile.profiling]
inherits = "release"
debug = trueSimilar advice applies to other compiled languages. For C++, you'll want to make sure the -g flag is included in the compiler invocation.
On macOS, samply cannot profile system commands, such as the sleep command or system python. This is because system executables are signed in such a way that they block the DYLD_INSERT_LIBRARIES environment variable, which breaks samply's ability to siphon out the mach_port of the process.
But you can profile any binaries that you've compiled yourself, or which are unsigned or locally-signed (such as anything installed by cargo install or by Homebrew).
Licensed under either of
- Apache License, Version 2.0 (
LICENSE-APACHEor http://www.apache.org/licenses/LICENSE-2.0) - MIT license (
LICENSE-MITor http://opensource.org/licenses/MIT)
at your option.
Unless you explicitly state otherwise, any contribution intentionally submitted for inclusion in the work by you, as defined in the Apache-2.0 license, shall be dual licensed as above, without any additional terms or conditions.