My configuration for Marlin 2.x and my CR-10 V3
Forked from: https://github.com/MarlinFirmware/Configurations/tree/import-2.0.x/config/examples/Creality/CR-10%20V2
My original post: https://www.pickysysadmin.ca/2020/08/16/marlin-2-x-for-a-cr-10-v3/
I have successfully printed using this configuration.
The firmware has X and Y offsets pre-configured in it for the BLTouch based on this mount: CR-10 V2 BL Touch Mount
I did not configure the Z offset in firmware since that might be unique per printer.
Pre-compiled firmware can be found in the Compiled Firmware folder or on the Releases page
New - There are now two builds of the firmware, one if you have a BLTouch and one if you do not.
Post firmware flash I recommend running the following GCode:
M502; Factory reset your printer
M500; Save settings
M851 Z-2.370; Set Z Probe Offset
M500; Save settings
M501; Load settings
Enjoy!
