Abstract
Thermal loading of rocks at high temperatures induces changes in their mechanical properties. In this study, a hard gabbro was tested in the laboratory. Specimens were slowly heated to a maximum temperature of 1,000°C. Subsequent to the thermal loading, specimens were subjected to uniaxial compression. A drastic decrease of both unconfined compressive strength and elastic moduli was observed. The thermal damage of the rock was also highlighted by measuring elastic wave velocities and by monitoring acoustic emissions during testing. The micromechanisms of rock degradation were investigated by analysis of thin sections after each stage of thermal loading. It was found that there is a critical temperature above which drastic changes in mechanical properties occur. Indeed, below a temperature of 600°C, microcracks start developing due to a difference in the thermal expansion coefficients of the crystals. At higher temperatures (above 600°C), oxidation of Fe2+ and Mg2+, as well as bursting of fluid inclusions, are the principal causes of damage. Such mechanical degradation may have dramatic consequences for many geoengineering structures.
Similar content being viewed by others
Explore related subjects
Discover the latest articles, news and stories from top researchers in related subjects.References
AmericanSocietyforTestingandMaterial (2001) Standard test method for splitting tensile strength of intact rock core specimens, ASTM Designation D 3967-95a.
Barbish, A. B. and Gardner, G. H. F. (1969), The effect of heat on some mechanical properties of igneous rocks, Soc. Petroleum Eng. J. 9(4), 395–402.
Chaki, S., Takarli, M., and Agbodjan, W. P. (2008), Influence of thermal damage on physical properties of a granite rock: Porosity, permeability and ultrasonic wave evolutions, Constr. Building Mater. 22(7), 1456–1461.
Chen, D. and Dollimore, D. (1995), Kinetic analysis of the calcium hydroxide formed in the hydration of pure C 3 S and with the addition of Ca (NO 3 ) 2 , J. Therm. Anal. Calorim. 44(5), 1001–1011.
Darot, M., Gueguen, Y., and Benchemam Z. (1985), Ductile–Brittle transition investigated by micro-indentation: results for quartz and olivine, Phys Earth Planet. Inter. 40(1985), 180–186.
Darot, M., Gueguen, Y., and Baratin M. L. (1992), Permeability of thermally cracked granite, Geophys. Res. Lett. 19(9), 869–872.
David, C., Menéndez, B., and Darot, M. (1999), Influence of stress-induced and thermal cracking on physical properties and microstructure of La Peyratte granite, Int. J. Rock Mech. Min. Sci. 36(4), 433–448.
Eberhardt, E., Stead, D., Stimpson B., and Read, R. S. (1998), Identifying crack initiation and propagation thresholds in brittle rock, Can. Geotech. J. 35, 222–233.
Fabre, G. and Pellet, F. (2006), Creep and time dependent damage in argillaceous rocks, Int. J. Rock Mech. Min. Sci. 43(6), 950–960.
Fei, Y., Mineral Physics and Crystallography, A Handbook of Physical Constants (Carnegie Institution of Washington, Geophysical Laboratory, Washington, DC 1995).
Ferrero, A. M., and Marini, P. (2001), Experimental studies on the mechanical behaviour of two thermal cracked marbles, Rock Mech. Rock Eng. 34(1), 57–66.
Fortin, J., Guéguen, Y., and Schubnel, A. (2007), Effect of pore collapse and grain crushing on ultrasonic velocities and Vp/Vs, J. Geophys. Res. 112, 1–16.
Fredrich, J. T. and Wong, T. F. (1986), Micromechanics of thermally induced cracking in three crustal rocks, J. Geophys. Res. 91(B12), 12743–12764.
Gatelier, N., Pellet, F., Loret, B. (2002), Mechanical damage of an anisotropic porous rock in cyclic triaxial tests, Int. J. Rock Mech. Min. Sci. 39(3), 335–354.
Heard, H. C. and Page, L. (1982), Elastic moduli, thermal expansion and inferred permeability of two granites to 508°C and 55 MPa, J. Geophys. Res. 87(B11), 9340–9348.
Homand, E. F. and Houpert, R. (1989), Thermally induced microcracking in granites, characterization and analysis, Int. J. Rock Mech. Min. Sci. Geomech. Abstr. 26(2), 125–134.
Homand, E. F. and Troalen, J. P. (1984), Behaviour of granites and limestones subjected to slow and homogeneous temperature changes, Eng. Geol. 20(3), 219–233.
Hugh-Jones, D. (1997), Thermal expansion of MgSiO 3 and FeSiO 3 ortho- and clinopyroxenes, Am. Mineral. 82(7,8), 689–696.
InternationalSocietyofRockMechanics (2007), The complete ISRM suggested methods for rock characterization, testing and monitoring: 1975–2006, In ISRM Commission on Testing Methods (ed. Ulusay, R. and Hudson, J. A.).
Jansen, D. P., Hutchins, A. D., and Young R. P. (1993), Ultrasonic imaging and acoustic emission monitoring of thermally induced microcracks in Lac du Bonnet granite, J. Geophys. Res. 98, 22231–22243.
Keshavarz, M. (2009), Contribution to experimental investigations on thermally and mechanically damaged crystalline rocks, PhD Thesis, University Joseph Fourier, Grenoble, France.
Keshavarz, M. Pellet, F., AminiHosseini, K., and Rousseau, C. (2008), Comparing the results of acoustic emission monitoring in Brazilian and uniaxial compression tests, Proc. 5th Asian Rock Mechanics Symposium, Tehran, Iran, 357–363.
Lion, M., Skoczylas, F., and Ledesert B. (2005), Effects of heating on the hydraulic and poroelastic properties of Bourgogne limestone, Int. J. Rock Mech. Mining Sci. 42(4), 508–520.
Mahmutoglu, Y. (1998), Mechanical behaviour of cyclically heated fine grained rock, Rock Mech. Rock Eng. 31(3), 169–179.
Martin, C. D. (1993), The strength of massive Lac du Bonnet granite around underground openings, Ph.D. thesis, University of Manitoba, Winnipeg, Canada.
Menéndez, B., David, C., and Darot, M. (1999), A study of the crack network in thermally and mechanically cracked granite samples using confocal scanning laser microscopy, Phys. Chem. Earth 24(7), 627–632.
Nasseri, M. H. B., Schubnel, A., and Young, R. P. (2007), Coupled evolutions of fracture toughness and elastic wave velocities at high crack density in thermally loaded Westerly granite, Int. J. Rock Mech. Min. Sci. 44(4), 601–616.
Pellet, F. and Fabre, G. (2007), Damage evaluation with P-wave velocity measurements during uniaxial compression tests on argillaceous rocks, Int. J. Geomech. ASCE, 7(6) 431–436.
Stanchits, S., Vinciguerra S., and Dresen G. (2006), Ultrasonic Velocities, Acoustic Emission Characteristics and Crack Damage of Basalt and Granite, Pure Appl. Geophys. 163, 974–993.
VandenKerkhof, A. M., Touret, J. L. R., Maijer, C., and Jansen, J. B. H. (1991), Retrograde methane-dominated fluid inclusions from high-temperature granulites of Rogaland, south western Norway, Geochimica et Cosmochimica Acta, 55(9), 2533–2544.
Wassermann, J., Senfaute, G., Amitrano, D., and Homand, F. (2009), Evidence of dilatant and non-dilatant damage processes in oolitic iron ore: P-wave velocity and acoustic emission analyses, Geophys. J. Int. 177(3), 1343–1356.
Acknowledgments
We would like to thank Drs. M.K. Jafari and K. Amini Hosseini from the International Institute of Earthquake Engineering and Seismology of Tehran for helpful comments on an initial draft of this manuscript. We would also like to thank Dr. A.M. Boullier from the Observatory of Earth and Planetary Sciences of Grenoble for assistance with microscopic investigations.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Keshavarz, M., Pellet, F.L. & Loret, B. Damage and Changes in Mechanical Properties of a Gabbro Thermally Loaded up to 1,000°C. Pure Appl. Geophys. 167, 1511–1523 (2010). https://doi.org/10.1007/s00024-010-0130-0
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00024-010-0130-0