MLK-12948 ARM: dts: imx7d-sdb: change the hardware reset gpio for mipi dsi

fancyfly · fancyfly · commit 77f61547834c · 2016-06-30T16:53:04.000+08:00
Change the hardware reset gpio to 'GPIO6_IO15' for mipi dsi to
allow fec2 and mipi dsi can run at the same time. This needs
some hardware rework as follows:
"
    1. Replace R631 with 100K resistor;
    2. Remove D14, D24;
    3. Solder the Cathode of the diode to R471,
       you can use BAT54HT1(ONSEMI) or NSR0320MW2T1G(ONSEMI);
    4. Solder the wire to the Anode end of the diode;
    5. Scrape the solder mask(Green oil)  of the MIPI Reset via,
       then solder the end of the wire to the via.
"

Signed-off-by: Fancy Fang &lt;chen.fang@nxp.com&gt;
(cherry picked from commit 0af28564e73f006f742a9af0db4bc5b8588e3490)
diff --git a/arch/arm/boot/dts/imx7d-sdb-mipi-dsi.dts b/arch/arm/boot/dts/imx7d-sdb-mipi-dsi.dts
@@ -11,23 +11,19 @@
 / {
 	mipi_dsi_reset: mipi-dsi-reset {
 		compatible = "gpio-reset";
-		reset-gpios = <&gpio1 4 GPIO_ACTIVE_LOW>;
+		reset-gpios = <&gpio6 15 GPIO_ACTIVE_LOW>;
 		reset-delay-us = <1000>;
 		#reset-cells = <0>;
 	};
 };
 
-&fec2 {
-	status = "disabled";
-};
-
 &lcdif {
 	disp-dev = "mipi_dsi_samsung";
 };
 
 &mipi_dsi {
 	pinctrl-names = "default";
-	pinctrl-0 = <&pinctrl_enet2_epdc0_en>;
+	pinctrl-0 = <&pinctrl_mipi_dsi_reset>;
 	lcd_panel = "TRULY-WVGA-TFT3P5581E";
 	resets = <&mipi_dsi_reset>;
 	status = "okay";
diff --git a/arch/arm/boot/dts/imx7d-sdb.dts b/arch/arm/boot/dts/imx7d-sdb.dts
@@ -562,6 +562,12 @@
 			>;
 		};
 
+		pinctrl_mipi_dsi_reset: mipi_dsi_reset_grp {
+			fsl,pins = <
+				MX7D_PAD_SAI1_TX_DATA__GPIO6_IO15 0x1b
+			>;
+		};
+
 		pinctrl_ecspi3_cs: ecspi3_cs_grp {
 			fsl,pins = <
 				MX7D_PAD_SD2_CD_B__GPIO5_IO9	0x80000000
